Fujitronic UG520H-x Benutzerhandbuch

Appendix - 1

Up until now it was necessary to debug the data by removing and mounting "connection cable between PC

and PLC" and "connection cable between POD and PLC." When using the ladder transfer function, it is

possible to write ladder programs or monitor the PLC memory via POD connected to PC without removing

and mounting each cable.

Applicable PLC

Ladder Transfer Function

(Transparent Mode)

Select PLC Type

CPU

Ladder comm. prg

I/F DRV

QnH(Q) series CPU

Q02(H), Q06H

MelQHCpQ.lcm

QnH(Q) series link

Q00, Q01

MelQnA.lcm

FX series CPU

FX1/2, FX0N

MelFx.lcm

FX2N/1N , FX2NC

FX1S

FX1S series CPU

FX2N series CPU

MelQHCpQ.tpb (1.240)

MelQnA.tpb (1.300)

MelFx.tpb (1.300)

Applicable Types

• UG221, UG320, UG420, UG520, UG420H-E

* This function cannot be supported with 1:n communication (multi-drop), multi-link and multi-link2

communication.

• The following types are unavailable for this function.

UG220, UG320HD

Version and Main Menu Screen

Available versions are as follows. The information can be shown on the [Main Menu] screen.

Main Menu

System Information

Screen Data

Information

Screen Data

Information

Size :

PLC Type: MITSUBISHIAnA/N/U series

Comment:

Error: Stop
Time-Out: 0.50 sec
Retry: 3

Connection: 1 : 1 Baud Rate: 19200
Signal Level: RS232C Data Length: 7
PLC Stat.No.: 0 Stop Bit: 1
Parity: Even
Send Delay: 0msec

SYSTEM PROG. VER.1.000

FONT
VER.1.000/1.000/1.000
JAPANESE 32

I/F DRV VER. 1.000
MELSEC AnA/N/U

1998- 9- 1 07 : 23 : 30

Editor : MJ1

Memory-Card

I/O Test

UG420H-TC1

786432

Extension

Editor:- - -

Main Menu

Extension Program Info.

Ladder Comm. Program

VER. 1.000 MELSEC QnH Q

CPU Port

SYSTEM PROG.

FONT

ITEM

Version

VER.1.280 or later

VER.1.210/1.130/1.000 or later

Pressing the [Extension] switch brings to the

[Extension Program Info.] screen.