Fujitronic UG520H-x Benutzerhandbuch

Appendix - 3

Settings and Communications

1. PLC type setting

Select [PLC Type] from the [System Setting] menu. Select a plc type available for the ladder transfer

function in the [Select PLC Type] dialog.

2. PLC programming software port setting

Select [Modular Jack] from the [System Setting] menu.

Select [Ladder Tool] for [Modular Jack 1] or [Modular Jack

2] in the [Modular Jack] dialog.

Communications with UG00S-CW editor (for screen data transfer)

On-line editing between the UG00S-CW editor and the POD is not possible.

If attempted, communications between the PLC programming software and the PLC will

not be performed correctly.

• With [Ladder Tool] selected for [Modular Jack 2], MJ1 will be [Editor Port] when the Main Menu screen

is displayed on the POD, and communications with the UG00S-CW editor become possible.

• With [Ladder Tool] selected for [Modular Jack 1], even when the Main Menu screen is displayed on

the POD, communications with the PLC programming software continue so that communications with

the UG00S-CW editor are not available.

When communicating with the UG00S-CW editor, refer to the following two ways.

* When UG420H-E is used, selected the way of Automatic switching after upgrading system

prg. of U420E.

Automatic switching (UG00S-CW ver.3.0.9.0 or later, sys. prg. ver.1.350 or later)

Check [Ladder communication is not used in Local mode.] on the [Environment Setting] tab menu

of the [Unit Setting] dialog in the [System Setting.].

Manual switching

Hold down the F2 switch for three

seconds. [Editor: ...] changes to

[Editor: MJ1] and communications

with the UG00S-CW editor become

possible.

When the F2 switch is held down for

three seconds, [Editor: MJ1] changes

to [Editor: ...] and communications

with the PLC programming software

become possible.

Editor:MJ1

Communications with
the PLC programming
software possible

Communications with
the UG00S-CW editor possible

Editor: