Benutzerhandbuch für Firstech, LLC. CM3 SERIES

Inhaltsverzeichnis

• Master Install Guide

  1
  • FOR DISTRIBUTION TO AUTHORIZED

    1
  • COMPUSTAR DEALERS ONLY

    1
  • 04/27/06

    1
    • 1WFM6R

      8
      • Dipswitch and Jumper Settings

        13
  • Alternator sensing:

    15
• CONNECTOR 1

  20
• CONNECTOR 2

  21
• CONNECTOR 3

  21
• CONNECTOR 4

  22
• CONNECTOR 5

  23
• CONNECTOR 6

  23
• (Pre-wired L.E.D.)

  23
• CONNECTOR 7

  24
• (Pre-wired Shock Sensor)

  24
• CONNECTOR 8

  24
• (Optional add on sensors; i.e. proximity)

  24
• CONNECTOR 9

  24
• (Pre-wired Remote Paging Sensor or R.P.S.)

  24
• CONNECTOR 10

  24
• (Optional Temperature sensor)

  24
• CONNECTOR 11

  25
• (Pre-wired Antenna Cable)

  25
• CONNECTOR 1

  28
• CONNECTOR 2

  28
• CONNECTOR 3

  29
• CONNECTOR 4

  30
• CONNECTOR 5

  30
• (Pre-wired L.E.D.)

  30
• CONNECTOR 6

  30
• (Pre-wired Shock Sensor)

  30
• CONNECTOR 7

  31
• (Pre-wired Remote Paging Sensor or R.P.S.)

  31
• CONNECTOR 8

  31
• (Pre-wired Antenna Cable)

  31
• CONNECTOR 1

  34
• CONNECTOR 2

  35
• CONNECTOR 3

  35
• CONNECTOR 4

  36
• CONNECTOR 5

  37
• (Optional Temperature sensor)

  37
• CONNECTOR 6

  37
• (Pre-wired Antenna Cable)

  37
• CONNECTOR 7

  37
• RS 232

  37
• CONNECTOR 1

  40
• CONNECTOR 2

  40
• CONNECTOR 3

  41
• CONNECTOR 4

  42
• (Pre-wired L.E.D.)

  42
• CONNECTOR 5

  42
• (Pre-wired Shock Sensor)

  42
  • Resetting all of Menu #1 or Menu #2

    48
  • Options Explained In Detail CM3000-3300-4200

    55
  • Additional Programming

    59
  • Common Diagrams

    65
  • Note: This diagram will not work with all turbo timers.

    70
  • Starter Kill Relay Installation

    71
  • Adding a Relay to Power a Secondary

    72
  • Ignition, Accessory, or Starter

    72
  • Adding Aftermarket Alarm Accessories

    73
  • Using the Ground While Armed Output

    73
  • Accessory Manuals

    75
  • OP500 Option Programmer

    77
  • Note1: The USB interface cable is for future use to connect the OP500 to a computer. Once the software for this feature is complete, additional instructions will be supplied.

    77
  • Channel Expander

    78
  • The channel expander is an add-on module that can be used to expand the existing two auxiliary outputs to a total of seven auxiliary outputs. Each one of these seven outputs can be individually programmed for pulsed, latched, or timed-latch output. The programming of the Channel Expander outputs must be done with the Option Programmer; the CompuStar remotes do not have the ability to access these programming options.

    78
  • Please note that the Auxiliary outputs are low-level outputs, and should not

    79
  • Programming the Outputs

    79
  • RPS – Remote Paging Sensor

    79
  • Temperature Sensor

    79