Benutzerhandbuch für Image Sensing Systems Inc. RTMS-X3

Inhaltsverzeichnis

• OPERATION OF RTMS

  1
• VEHICLE DETECTION

  2
• OUTPUTS

  2
• RTMS OPTIONS

  3
• POWER OPTIONS

  3
• DATA COMMUNICATION OPTIONS

  3
• RTMS INSTALLATION

  3
• INCOMING INSPECTION

  3
• INSTALLATION STEPS

  3
• RTMS MOUNTING AND AIMING

  5
• Sidefired Configuration

  5
• Set-back and Mounting Height

  5
• Initial Aiming Instruction

  6
• Pointing RTMS away from heavy structures

  6
• Sidefired mounting in Intersection Stop Bar Detection

  7
• Forward-looking configuration

  8
• Offset of RTMS in Forward-looking configuration

  8
• SETUP OF THE RTMS

  9
• THE PC REQUIREMENTS

  9
• THE RTMS SETUP UTILITY (WINRTMS)

  9
• Installation

  9
• Direct and Multi-drop Communication Modes

  9
• GETTING STARTED

  10
• WinRtms Setup Utility Screen

  11
• SETUP SEQUENCE

  12
• Automated Wizard setup

  13
• Aiming Verification and Manual Sensitivity setting

  13
• RTMS Operating Modes

  14
• ZONE SETUP – SIDEFIRED MODES

  15
• Automatic Zone Setup

  15
• Manual Zone Setup

  15
• Fine Tune

  16
• Fine Tune Setup

  18
• ZONE SETUP – FORWARD-LOOKING MODE

  18
• Manual Zone Setup – Forward-looking Mode

  18
• ADVANCED PARAMETERS

  19
• ADDITIONAL FORWARD-LOOKING PARAMETERS

  21
• Height and Offset

  21
• Alarm Speed Limit

  21
• Speed bins

  21
• COUNT VERIFICATION

  22
• SPEED CALIBRATION

  23
• Sidefired Speed Calibration

  23
• Sidefired Automatic Speed Calibration

  23
• Sidefired Manual Speed Calibration

  24
• Forward-Looking Speed calibration

  24
• Per Vehicle Speed

  24
• DATA MODE

  25
• CUSTOMIZATION OF TRAFFIC DATA (RTMS X3/K3 REV 6.1 AND UP)

  26
• THE TRAFFIC STATISTICS DISPLAY AREA

  26
• Sidefired Data Definitions

  27
• Forward-looking Data Definitions

  28
• NON-SETUP FUNCTIONS OF THE RTMS SETUP UTILITY

  29
• SETTING THE RTMS SETUP UTILITY COMMUNICATION MODE

  29
• SETTING THE PC COMMUNICATION

  29
• Setup of Integral Digital Spread Spectrum Modem

  30
• COMMUNICATING WITH MULTIPLE RTMS UNITS IN MULTI-DROP MODE

  30
• ACCESSING A SPECIFIC SENSOR IN MULTI-DROP MODE

  30
• SAVING AND RETRIEVING SETUP FILES

  31
• DATA RECORDING

  31
• SELF-TEST DIAGNOSTIC

  32
• SUPPORT FOR OTHER LANGUAGES

  32
• CABLES

  33
• THE RTMS CABLE

  33
• RTMS MS Connector pin out

  34
• Power Cabling notes

  34
• RTMS SERIAL COMMUNICATIONS AND CABLING

  35
• Standards and Nomenclature

  35
• RTMS Serial Port Wiring

  36
• RS-232 Port wiring

  36
• RS-232 Port wiring – for RTMS with DSS Option

  36
• RS-485 Serial Port Wiring ( Models X3/K3 only)

  37
• TCP/IP (Ethernet) Port Wiring

  37
• Modem cabling

  38
• SERVICE AND WARRANTY

  39
• SERVICE INFORMATION

  39
• EIS WARRANTY

  39
• TECHNICAL SPECIFICATIONS

  40
• MICROWAVE SIGNAL AND COVERAGE AREA

  40
• MEASUREMENTS, THEIR ACCURACIES AND RANGES

  40
• MECHANICAL

  40
• INTERFACES

  40
• Contacts

  40
• Data Ports

  41
• POWER REQUIREMENTS AND CONSUMPTION

  41
• SURGE IMMUNITY

  41
• ENVIRONMENTAL CONDITIONS

  41
• ELECTROMAGNETIC INTERFERENCE

  41
• RELIABILITY

  41
• ACCURACY PERFORMANCE CONDITIONS!

  42
• RTMS TROUBLESHOOTING GUIDE

  43
• WIRING CONFIGURATIONS FOR MULTIPLE RTMS

  45
• MODEM SHARING

  45
• MODEM-SHARING CABLE CONSTRUCTION

  45
• MULTI-DROP WIRING

  46
• SETTING RTMS IP ADDRESS

  47
• PROGRAMMING AN IP ADDRESS

  47
• RECOVERY PROCEDURES

  48
• Recovery of MAC address

  48
• Recovery of IP address (MAC address known)

  48
• INTERNAL DSS MODEM SETUP

  49
• RECOMMENDED RTMS SETUP SHEETS

  1
• RTMS SET UP SHEET – HIGHWAY - COMPLETED SAMPLE

  1
• RTMS SET UP SHEET – INTERSECTION - COMPLETED SAMPLE

  2
• INDEX

  1
• RTMS MICROWAVE BEAM AND ITS FOOTPRINT

  1
• RTMS MOUNTING CONFIGURATIONS

  1
• REFLECTED SIGNALS WITHIN THE RTMS BEAM

  2
• INSTALLATION OF RTMS BRACKET

  3
• SET-BACK AND HEIGHT REQUIREMENTS

  5
• AIMING TO THE FIRST 1/3 OF THE MONITORED LANES

  6
• SIDEFIRED MOUNTING ON HEAVY STRUCTURES

  6
• MOUNTING RTMS AT INTERSECTIONS

  7
• CORRECT AND INCORRECT AIMING IN FORWARD-LOOKING CONFIGURATION

  8
• OFFSET FORWARD-LOOKING RTMS MOUNTING

  8
• RTMS SETUP UTILITY COMMUNICATING WITH THE SENSOR

  11
• ZONE ICONS AND TARGET BLIPS

  16
• THE EFFECT OF FINE TUNE CONTROL ON VEHICLE BLIPS

  17
• CUSTOMIZATION OF TRAFFIC DATA

  26
• SIDE-FIRED MODE SETUP AND TRAFFIC DATA (F/W REV 6.1)

  27
• SIDEFIRED STATISTICAL TRAFFIC DATA

  27
• FORWARD-LOOKING MODE TRAFFIC DATA

  28
• SAMPLE RECORDED FILE FORMAT

  32
• MS CONNECTOR VIEWS

  34
• PIN NUMBERING OF D-TYPE CONNECTORS

  35
• RTMS RS-232 PORT WIRING

  36
• RTMS RS-485 PORT WIRING

  37
• RTMS ETHERNET PORT WIRING

  37
• RTMS TO MODEM CABLES

  38
• MODEM SHARING Y-CABLES

  45
• MULTI-DROP WIRING CONFIGURATION

  46
• RS-485 PORT MULTI-DROP WIRING

  46
• Aiming

  5
• Alarm Forward Look Mode

  14
• Alarm Speed Limit

  21
• Automatic Speed Calibration

  23
• Long vehicle (LV)

  20
• Loop emulation (6ft)

  26
• Lynch pin

  4
• Barrier

  2
• Manual Speed Calibration

  23
• Mid. Intersection

  14
• Modem cabling

  38
• Crimping tool

  33
• Modem sharing

  45
• Mounting

  5
• Mph

  12
• MTBF

  41
• DCD

  35
• DCE

  35
• NORMAL Data mode

  30
• DSS modem Setup

  49
• DTE

  35
• Per Vehicle Speed

  24
• Period

  12
• Power Management

  20
• Fail-Safe

  2
• Power requirements

  41
• FCC

  41
• Firmware Revision

  32
• Footprint

  8
• Real time clock

  26
• Reliability

  41
• Headway

  19
• Rtms.ini file

  9
• High Resolution Occupancy

  26
• Rtmslng.txt file

  9
• Incoming Inspection

  3
• Tick clock

  26
• Serial Port speed

  29
• USB

  9
• Set-back

  5
• Setup Files

  31
• Setup Sequence

  12
• Vehicle Detection

  2
• Sign-bridge

  6
• Speed bins

  21
• Speed trap

  14
• SPIDER

  25
• Stop Bar Detection

  7
• TCP/IP

  37