BenutzerhandbuchInhaltsverzeichnisMaster Table of Contents8Safety2Section A - Installation9Section B - Operation19Section C - Accessories25Section D - Maintenance29Section E - Theory of Operation35Section F - Troubleshooting & Repair39Symptoms42Major Physical or Electrical Damage is Evident.42No weld output and no auxiliary power. Engine runs normally.42No weld output in AC or DC Modes. The auxiliary power (480, 23 & 115 VAC) is normal. Engine runs normally.43No DC welding output. AC welding output and auxiliary power is normal.43No AC welding output. DC welding output and auxiliary power is normal.44No constant voltage (CV) welding output. Constant current (CC) and the auxiliary power are operating normally.44Engine will not go to high idle when attempting to weld or when the auxiliary power is loaded. Welding output and auxiliary power output is normal when Idler Switch is in the“HIGH” position.45Engine will not go to high idle when attempting to weld. Welding output is normal when Idler Switch is in “HIGH” position. Automatic idle function works properly when the auxiliary power is loaded.45Engine will not idle down to low speed. Machine has normal weld output and auxiliary power.46Engine will not crank or cranks very slow.46The Engine shuts off.47Engine does not develop full power.47Engine tries to start when S3 is in start position, then shuts off when switched to run.47Engine will not start with S3 in start position, but then tries to start or does start when S3 is switched to run position.47Engine will not shut off when S3 is placed “OFF” position.47Engine continues to crank when S3 is switched to “RUN” position.47The welding arc is “cold.” Engine runs normally (3700 RPM no load). Auxiliary power is functioning normally.48Welding output is low with little or no control. Auxiliary output is also low.48Section G - Electrical Diagrams91Größe: 3,49 MBSeiten: 94Language: EnglishHandbuch öffnen