BenutzerhandbuchInhaltsverzeichnisRelated products1Related documents11.0 Introduction42.0 Equipment42.1 Equipment supplied42.2 Equipment required63.0 Technical configuration63.1 Overview63.1.1 Power switch (On/Off)63.1.2 Configuration DIP switch63.1.3 Function LEDs63.1.4 Reset switch63.1.5 Clock out connector63.1.6 Serial port 163.1.7 Serial port 273.1.9 Antenna connector73.1.10 DC power input73.2 Configuration DIP switch73.2.1 DIP switch 1 – GPIO3 /GYROIN input73.2.2 DIP switch 2 – GPIO15 /FR input73.2.3 DIP switch 3 – BOOT from serial mode83.2.4 DIP switch 4 – GPIO1/W_TICKS input83.2.5 DIP switch 5 – RTC backup power enable83.2.6 DIP switch 6 – Antenna preamp power select (3.3 V or 5/12 V)83.2.7 DIP switch 7 – Antenna preamp power select (5 V or 12 V)83.2.8 DIP switch 8 – Antenna preamp power enable83.3 Function LEDs93.3.1 1PPS93.3.2 Power93.3.3 AUX93.3.4 GPIO93.4 Clock out connector93.5 Internal configuration113.6 Jupiter 30 module on adapter board134.0 Operating instructions134.1 Initial connection and operation .134.2 Positioning the GPS antenna144.3 Connecting an RTCM differential source144.4 Operating the GPS Analyser software154.4.1 VisualGPS154.4.2 SiRFDemo155.0 Acronyms used in this document16Figure 2-1 Equipment supplied in the Jupiter 30 GPS Development Kit4Figure 3-1 Front and back panels of the Jupiter 30 development unit5Figure 3-2 Configuration DIP switch7Figure 3-5 Internal layout of the development unit8Figure 3-3 Function LEDs on front panel9Figure 3-6 Jupiter 30 adapter board10Figure 3-4 Pin layout of the clock out connector11Figure 4-1 Development unit test equipment15Table 3-1 DIP switch settings7Table 3-2 Pin functions of the clock out connector9Table 3-3 Mating connector part description11Table 3-4 Pin functionality11Table 3-5 Signals available on the test points12Table 3-6 Connections J1 (2 mm pitch header) and J2 (2.54 mm pitch header)13Größe: 956 KBSeiten: 17Language: EnglishHandbuch öffnen