Инструкции для Navman la000578a

Содержание

• Related products

  1
• Related documents

  1
• 1.0 Introduction

  4
• 2.0 Equipment

  4
• 2.1 Equipment supplied

  4
• 2.2 Equipment required

  6
• 3.0 Technical configuration

  6
• 3.1 Overview

  6
• 3.1.1 Power switch (On/Off)

  6
• 3.1.2 Configuration DIP switch

  6
• 3.1.3 Function LEDs

  6
• 3.1.4 Reset switch

  6
• 3.1.5 Clock out connector

  6
• 3.1.6 Serial port 1

  6
• 3.1.7 Serial port 2

  7
• 3.1.9 Antenna connector

  7
• 3.1.10 DC power input

  7
• 3.2 Configuration DIP switch

  7
• 3.2.1 DIP switch 1 – GPIO3 /GYROIN input

  7
• 3.2.2 DIP switch 2 – GPIO15 /FR input

  7
• 3.2.3 DIP switch 3 – BOOT from serial mode

  8
• 3.2.4 DIP switch 4 – GPIO1/W_TICKS input

  8
• 3.2.5 DIP switch 5 – RTC backup power enable

  8
• 3.2.6 DIP switch 6 – Antenna preamp power select (3.3 V or 5/12 V)

  8
• 3.2.7 DIP switch 7 – Antenna preamp power select (5 V or 12 V)

  8
• 3.2.8 DIP switch 8 – Antenna preamp power enable

  8
• 3.3 Function LEDs

  9
• 3.3.1 1PPS

  9
• 3.3.2 Power

  9
• 3.3.3 AUX

  9
• 3.3.4 GPIO

  9
• 3.4 Clock out connector

  9
• 3.5 Internal configuration

  11
• 3.6 Jupiter 30 module on adapter board

  13
• 4.0 Operating instructions

  13
• 4.1 Initial connection and operation .

  13
• 4.2 Positioning the GPS antenna

  14
• 4.3 Connecting an RTCM differential source

  14
• 4.4 Operating the GPS Analyser software

  15
• 4.4.1 VisualGPS

  15
• 4.4.2 SiRFDemo

  15
• 5.0 Acronyms used in this document

  16
• Figure 2-1 Equipment supplied in the Jupiter 30 GPS Development Kit

  4
• Figure 3-1 Front and back panels of the Jupiter 30 development unit

  5
• Figure 3-2 Configuration DIP switch

  7
• Figure 3-5 Internal layout of the development unit

  8
• Figure 3-3 Function LEDs on front panel

  9
• Figure 3-6 Jupiter 30 adapter board

  10
• Figure 3-4 Pin layout of the clock out connector

  11
• Figure 4-1 Development unit test equipment

  15
• Table 3-1 DIP switch settings

  7
• Table 3-2 Pin functions of the clock out connector

  9
• Table 3-3 Mating connector part description

  11
• Table 3-4 Pin functionality

  11
• Table 3-5 Signals available on the test points

  12
• Table 3-6 Connections J1 (2 mm pitch header) and J2 (2.54 mm pitch header)

  13