Yamaha RX-A1030BL User Manual

CONFIGURATIONS

➤ Configuring the system settings (ADVANCED SETUP menu)

En

Turn on/off the remote control sensor on the main unit. While the remote control sensor 
is turned off, you cannot control the unit from the remote control.

Change the unit’s remote control ID so that it matches the remote control’s ID (default: 
ID1). When using multiple Yamaha AV receivers, you can set each remote control with a 
unique remote control ID for its corresponding receiver.

ID1 (default), ID2

■

Perform each of the following steps within 1 minute. Otherwise, the setting will be 
automatically canceled.

Once the remote control ID is registered successfully, SOURCE blinks twice.

If it blinks six times, registration failed. Repeat from Step 1.

• The registered remote control codes (p.123) are not cleared even if you change the remote control ID.

(Asia and General models only)

Change the FM/AM tuning frequency setting of the unit depending on your country or 
region.

Switch the video signal type of the unit so that it matches to the format of your TV.

NTSC, PAL

U.S.A., Canada, Korea and General models: NTSC

Other models: PAL

ON (default)

Turns on the remote control sensor.

OFF

Turns off the remote control sensor.

SPIMP.-

            O N

R E M O T E  S E N S O R

SPIMP.-

           I D 1

R E M O T E  C O N  A M P

FM100/AM10

Select this when you want to adjust the FM frequency by 100-kHz 
steps and AM by 10-kHz steps.

FM50/AM9 (default)

Select this when you want to adjust the FM frequency by 50-kHz steps 
and AM by 9-kHz steps.

      F M 5 0 / A M 9

T U N E R  F R Q  S T E P

SPIMP.-

          N T S C

  T V  F O R M A T