Chief Manufacturing 8805-000009 User Manual
Instruction Manual
Plasma Display Electric Pop-Up Lift
15
Remote (RC-10)
Wire for remote (RC-10) operation as follows (see Figure 21):
1.
Install a jumper wire between terminals #6 and
terminal #2 (see Figure 22).
terminal #2 (see Figure 22).
2.
Connect the white wire of the RC-10 controller unit to
terminal #1 (see Figure 23).
terminal #1 (see Figure 23).
3.
Connect the red wire of the RC-10 controller unit to
terminal #2.
terminal #2.
4.
Connect the black wire of the RC-10 controller unit to
terminal #5.
terminal #5.
5.
Connect the power source to the lift.
NOTE: If the unit does not activate, check to make sure the 9 volt
battery is working and make sure the dip switches in the send-
ing unit match the dip switch settings in the controller unit (see
Figure 24).
ing unit match the dip switch settings in the controller unit (see
Figure 24).
Figure 22. Contacts Connection
Figure 23. Contacts Connection
Black lead
Red lead
RC-10 Controller
Circuit Board Box Assembly
RC-10 Remote
Figure 21. Contacts Connection
Figure 24. Dip Switches