Chief Manufacturing JWP-V User Manual
Installation Instructions
JWP-V
4
INTRODUCTION
There are 3 main steps in the JWP-V installation
process. These steps are:
process. These steps are:
Selecting an appropriate mounting configuration.
Connect display cables
Making required adjustments
Before starting the installation process, determine the
correct mounting hole configuration for your display by
reviewing the information located within Table 2 at right.
correct mounting hole configuration for your display by
reviewing the information located within Table 2 at right.
NOTE: If the displays mounting hole configuration does
not match those identified at right, a custom MSB
interface is required. Refer to a Chief Mfg. cross
reference or visit to
interface is required. Refer to a Chief Mfg. cross
reference or visit to
to identify
the appropriate MSB for your display.
Figure 1. Typical VESA Mounting Hole
configurations
200mm x 100mm
100mm x 100mm
200mm x 200mm