Chief Manufacturing MSP-DCCMD User Manual

 Model MSP-DCCMD

Installation Instructions

WARNING:  It is the responsibility of the installer to 
verify that the surface to which the mount is anchored 
will safely support the combined load of all attached 
components and equipment.

To install the mount:

1. Determine the exact mounting location prior to 

installation, considering the unit’s swing and 
extension radius.

2. Using the wall bracket (150) as a template, mark the 

two pilot holes for mounting the wall bracket.            
(see  figure 2)

3. Drill two 1/4” pilot holes a minimum depth of 2” into the 

wood stud.

NOTE:   Make sure the wall bracket is level before 

installing the lag bolts.

4. Using a 9/16” socket wrench, install two lag bolts (20) 

to secure the wall bracket (150) to the wall. Do not 
overtighten the lag bolts.

IMPORTANT ! : Overtightening lag bolts may cause 
bracket to compress into soft wall surface, resulting in 
difficult mount installation or improper engaging of set 
screw in step 2 below.  If this occurs, remove bracket, 
install 3/8" steel washers as required between bracket 
and wall surface, and reinstall bracket.

•

For a flush mount application, perform the “Attach 

Mount to Wall Bracket” on page 6 and then 

perform the “Flush Mount Centris Bracket to 

Display” on page 7.

•

For a recessed mounting application, omit the 

procedure to “Attach Mount to Wall Bracket” on 

page 6 and proceed to the “Recess Mount Centris 

Bracket to Display” on page 7.

1. Align the top of the mount (10) with the top of the wall 

bracket (150). Push the bottom of the mount against 
the  bottom of the wall bracket until the mount fits 
snugly in place (see Figure 3).

2. Using the 5/32” hex wrench (180), secure the mount 

to the wall bracket by tightening the set screw         
(see  figure 3).  Ensure set screw engages back side 
of bracket to properly secure mount.

Wood

Stud

150

20

10

150