Precor P10 User Manual

Assembling the Treadmill

To complete assembly of the treadmill base:

Important: Use your fingers to align and thread the four hood

fasteners properly. Then use a wrench to tighten the hood

fasteners completely as described in the following step.

1. Thread the four black buttonhead screws (with black

washers) into their holes, leaving gaps of about ¹₄ inch

between the washers and the surface of the treadmill

frame.

2. Place the front of the hood on the two front screws. Make

sure the screws are aligned with the notches in the hood

and the washers are outside the hood.

3. Lower the back of the hood until the side screws rest

inside the notches in the internal wall of the hood. Make

sure the washers are outside the internal wall (on the

same side as the screw heads).

4. Tighten all four screws securely, starting with the front

screws.
Note: Using a hex wrench, reach through the openings in

the outer sides of the hood to tighten the side screws.

Figure 13: Hood and fastener placement

Checking Treadmill Alignment and

Adjusting the Running Belt

Before you allow anyone to use the treadmill, you must check

the alignment of the running belt and adjust it as needed. For

chapter.