DISH Network 129418 User Manual

To read out the remote control address setting:

1. Press and hold the SAT mode button for three seconds 

until all mode buttons light. Then, let go.

2. Press the POUND (#) button twice while watching 

the SAT mode button. 

3. Count the number of times the SAT mode button 

flashes. This number is the remote address. For 
example, if the SAT mode button flashes 6 times, this 
indicates the remote address is set to 6. 

To use the remote to control other devices (such as a TV, VCR, DVD 
player, tuner, or amplifier), you must first program it to control these 
other devices. You can do this by either following the instructions in 
Setting Up Using Device Code Tables on page 9, or the Setting Up 
Using Device Codes Scan procedure described on page 10.

If you are programming the remote to control a combination device, 
such as a TV/VCR or a TV/DVD, program the remote control in one 
mode, and then repeat the procedure in the other mode. For example, to 
program the remote to control a TV/VCR using code 748, follow the 
instructions to program the remote to control the TV using code 748, 
and then repeat the instructions for the VCR using the same code.

You can program your remote control in Limited Mode to keep from 
accidentally changing the channel on your TV or VCR. When you use 
the remote to control your TV in Limited Mode, you will only be able 
to use the POWER, MUTE, and VOLUME buttons to control your TV. 
Also, when you use the remote to control your VCR in Limited Mode, 
you will only be able to use the POWER and VCR function buttons. 
The section Setting Up Using Device Codes Tables has a step that tells 
the remote control to go into Limited Mode.

Note: Limited Mode can not be used with audio amplifiers.

text_dishpvr.fm  Page 8  Tuesday, March 2, 2004  12:35 PM