Suunto t3 User Manual
Use UP and DOWN buttons
to toggle between the
following Speed and
Distance setting submenus:
autolap, speed, calibrate, pair
a POD and general.
to toggle between the
following Speed and
Distance setting submenus:
autolap, speed, calibrate, pair
a POD and general.
2 sec
Long press the
ENTER button in
Speed and
Distance mode to
enter Speed and
Distance settings
menu.
ENTER button in
Speed and
Distance mode to
enter Speed and
Distance settings
menu.
Autolap settings
In the Autolap menu, you can set the autolap function on or off and set the distance for each lap.
When autolap is set on, and you have a paired speed and distance POD, the device beeps and
shows total distance, average lap speed, and lap time for 5 seconds with each lap.
When autolap is set on, and you have a paired speed and distance POD, the device beeps and
shows total distance, average lap speed, and lap time for 5 seconds with each lap.
Speed settings
In the Speed menu, you can set the speed limit on or off and define the upper and lower speed
limits.
limits.
Calibrate settings
In the Calibrate menu, you can calibrate your Suunto Foot POD or Suunto Bike POD. An alternative
way of calibrating your POD is to run or cycle a known distance, say 10 km, using the POD. If you
do not reset the stopwatch after completing the distance, you can correct the distance shown, for
example 9.6 km, from the settings. The device will then update the calibration value accordingly.
The GPS POD is also listed in the Calibrate menu but the calibration has no effect on the GPS
POD measurements. You will need this calibration only if you have, for instance, two Bike PODs
for different bikes. You can then pair one of them as GPS POD and use the calibration in the same
way as you normally would with Bike POD.
way of calibrating your POD is to run or cycle a known distance, say 10 km, using the POD. If you
do not reset the stopwatch after completing the distance, you can correct the distance shown, for
example 9.6 km, from the settings. The device will then update the calibration value accordingly.
The GPS POD is also listed in the Calibrate menu but the calibration has no effect on the GPS
POD measurements. You will need this calibration only if you have, for instance, two Bike PODs
for different bikes. You can then pair one of them as GPS POD and use the calibration in the same
way as you normally would with Bike POD.
24