Heath Zenith Multi-Channel Remote Control User Manual

© 2007 HeathCo LLC 

598-1145-01

•  Operational range of up to 100 feet.
•  Controls all Heath

®

/Zenith RF Tech Communica-

tions™ products.

•  FCC/IC tested and approved.
•  Flash control on compatible receivers when using 

the Panic feature.

ALL ON

ALL OFF

OFF

DIM

PANIC

A

B

ON

The Multi-Channel Remote 
Control  is  designed  for  3 
Volt operation:
1.  Remove battery cover 

on  rear  of  housing  by 
pushing clip and lifting 
up.

2.  Install  2-AAA  bat-

teries  (not  included) 
according  to  polarity 
markings. For best per-
formance use alkaline 
batteries.

Battery Cover

Two AAA Batteries 

(Not Included)

*dIM Control: Dims lighting controls that are equipped with the dimming feature. Pressing DIM will toggle through the different dim 
levels. Each time the DIM button is pressed, the control LED will momentarily light.
The receiver saves the last dim setting used. To recall the last dim setting, press the DIM control once.
Note: Not all lighting controls have the DIM and PANIC (flash) feature.

Control Group and Indicators - Select 

Group A or B lighting controls.

ALL ON - Turns all lights within a Group ON. 

Select either Group A or B then press ALL ON.

Light Control - ON

PANIC* - All lights within a Group will 

flash ON and OFF. Select either Group A 

or B then press PANIC.

ALL OFF - Turns all lights within a 

Group OFF. Select either Group A or 

B then press ALL OFF.

Control Identification - Remove clear plastic film by 

placing two fingers on the plastic and “pinching” the 

plastic. Remove card. Write on the card to label each 

control. Replace card and plastic film.

Light Control - OFF

Light Control Selectors

Light Control - DIM*

ON

ALL ON

ALL OFF

DIM

PANIC

A

B

OFF