Weber SILVER D User Manual

VENTILATION



WARNING: Air holes must be provided in the

structure at the top and bottom to provide ventilation in

the event of a gas leak.

Air holes can be located in a low visibility area and should

be protected by screening material to prevent rodents and

insects from entering the structure. Air holes will also help

dry moisture.

Summit

Built- In cabinet vents (part # 36312 / #61429) are

available from your dealer or call Customer Service at

1-800-466-1071.

Note: These drawings are only a reference.

• Cross ventilation must be incorporated in the supporting

structure. We recommend a minimum of 100 square

inches of venting per side.

• Vents should be on two sides of the structure.

• The above drawings are for reference only.

• Location of the vents should be from the center, outward.

• Locate the vents at both the bottom of the structure and

at the top of the structure.

• The bottom vents should be as close to ground level

as possible. Make sure the vent area is not blocked by

interior supports of the structure.

• We recommend vents with screens.

• Access doors to the structure are not considered vents.

• Clean the vents periodically.



DANGER: Failure to follow recommended minimum

venting instructions can cause gas to collect in the

structure in the event of a gas leak. This may result in

a fire or an explosion which can cause serious bodily

injury or death, and damage to property.

��

GAS SUPPLY

CONNECT GAS SUPPLY

A 58" inch corrugated gas line is supplied with the grill. This

line needs to pass through the gas inlet opening to the main

gas supply.

1) Connect the corregated gas line to the manifold located

on the right hand side of grill under the control panel.

Note: Leave an access in the “island” structure for gas

supply and regulator service not inside the grill structure.

Weber

has a gas line and regulator access door (part

# 36311) available from your dealer or call Customer

Service at 1-847-446-1071.

Typical tank cabinet

or tank enclosure location

The corrugated line passes through the "Island Structure"

cavity to the regulator connection inside the Summit

Built-In

tank cabinet (#21280) or the hose and regulator connection

from kit # 21287. (Shown below)