Panasonic MN101C77C User Manual

Chapter 2  CPU Basics

II - 38

Reset

The CPU contents are reset and registers are initialized when the NRST pin is pulled to low.

„

Initiating a Reset

There are two methods to initiate a reset.

(1)

Drive the NRST pin low.

NRST pin should be held "low" for more than OSC 4 clock cycles (200 ns at 20 MHz).

(2)

Setting the P2OUT7 flag of the P2OUT register to "0" outputs low level at P27 (NRST) pin. And

transferring to reset by program (software reset) can be executed. If the internal LSI is reset

and register is initiated, the P2OUT7 flag becomes "1" and reset is released.

NRST pin

4 clock cycles

(200 ns at 20 MHz)

 [ 

 Chapter 4. 4-4-2  Registers  ]

On MN101C77 series, the starting mode is NORMAL mode that high oscillation is the base

clock.

When NRST pin is connected to low power voltage detection circuit that gives pulse for

enough low level time at sudeen unconnected. And reset can be generated even if NRST pin

is held "low" for less than OSC 4 clock cycles, take notice of noise.