Woodstock M1001 User Manual

-11-

M1001 6" x 26" Vertical Mill

Note: The circuit requirements listed in this

manual apply to a dedicated circuit—where

only one machine will be running at a

time. If this machine will be connected to

a shared circuit where multiple machines

will be running at the same time, consult

a qualified electrician to ensure that the

circuit is properly sized for safe operation.

Circuit Information

A power supply circuit includes all electrical equipment

between the breaker box or fuse panel in the building

and the machine. The power supply circuit used for

this machine must be sized to safely handle the full-

load current drawn from the machine for an extended

period of time. (If this machine is connected to a circuit

protected by fuses, use a time delay fuse marked D.)

Circuit Requirements for 110V

This machine is prewired to operate on a 110V power

supply circuit that has a verified ground and meets the

following requirements:

Nominal Voltage ................................... 110V/120V

Cycle ........................................................60 Hz

Phase .............................................. Single-Phase

Minimum Circuit Size ............................... 20 Amps

Plug/Receptacle ................................... NEMA 5-15

Circuit Requirements for 220V

Nominal Voltage ................................... 220V/240V

Cycle ........................................................60 Hz

Phase .............................................. Single-Phase

Minimum Circuit Size ............................... 15 Amps

Plug/Receptacle ................................... NEMA 6-15

This machine can be converted to operate on a 220V

power supply (refer to

Voltage Conversion later in this

section). The intended 220V circuit must have a verified

ground and meet the following requirements: