Panasonic DVD-LS865 User Manual

Page of 20
14
RQT
9
201
Enjoying in various situations
Enjoying in various situations
Enjoying in a car 
You can enjoy video in the back seat attaching the unit to the back of the 
front seat.
≥ Please insert the disc before attaching the unit to the headrest 
mounting bracket.
1 Attach the headrest mounting bracket to the front 
seat.
2 Adjust the monitor.
3 Attach the unit to the bracket.
While holding the unit with both hands, line up the unit just below the 
protruding sections on the bracket. Press the unit down about 4 to 5 mm 
so that the protrusions on the bracket fit into the holes on the bottom of 
the unit.
≥ Please check the following points before use.
– The bracket is securely fastened to the unit.
– The unit is not loose and cannot be lifted upwards.
≥ Do not leave the unit on a surface that may become hot such as a dashboard. The unit is not heat-resistant so may malfunction.
≥ DRIVER MUST NOT OPERATE OR VIEW THIS UNIT WHILE OPERATING THE VEHICLE.
Doing so will distract the driver and could cause a collision resulting in serious injury or property damage.
Enjoying video in the back seat with the Headrest Mounting Bracket
≥ Do not attach or detach the unit or the bracket while the car is 
moving.
≥ Do not attach the unit in the following locations:
– anywhere other than the back of the front seat
– where it can be viewed or operated by the driver
– where it interferes with the driver’s operation of the vehicle
– where it interferes with the operation of an airbag
≥ Ensure that the bracket belt is securely fastened and check the 
lock on the unit. Refer to installation instructions.
In the event of an accident, sudden acceleration or braking, the unit 
could become loose and cause injury or property damage.
≥ Only use the Panasonic bracket supplied to attach the unit to 
the car seat.
Rotate the monitor backwards so the screen is facing out. 
(
➜ 4, Adjusting the LCD angle)
Headrest Mounting 
Bracket 
(included)
2 Close the buckle and adjust the belt until it fits tightly 
around the headrest.
1 Adjust the headrest so there is an open space of about 3 cm.
Attach to the seat so 
that the label side of 
the bracket can be 
seen from the rear of 
the seat.
Side view
If this space is larger than 3 cm, 
the unit could become loose and 
cause injury in the event of an 
accident etc.
DO 
DO NOT
≥ Depending on the type of headrest, you may not be able to attach the 
bracket.
1 Press the release buttons (left and right) in towards the center of 
the bracket.
2 Lift the unit up to release it.
≥ Do not press the release buttons any time other than when detaching 
the unit from the bracket.
30˚
Line up the protruding 
sections here.
Use the monitor in the open position 
as shown in the illustration below to 
prevent abnormal audio or damage 
resulting from vibrations in the car.
The angle of the monitor can be 
adjusted up to about 30
o.
Diagram of the 
attached bracket and 
unit
≥ The angle of 
the monitor 
may shift 
while driving 
due to 
vibration, etc.
When correctly 
attached, you will 
hear a locking 
sound.
click!
23 cm or less
In the event of an accident etc., the unit 
could become loose and cause injury.
DO 
DO NOT
Releasing the unit from the bracket
Release button
RQT9201-P.book  14 ページ  2008年2月6日 水曜日 午後4時38分