Sharp DK-KP85PH User Manual

Page of 34
E-24
EN
Troubleshooting chart (continued)
 
Care of compact discs
Compact  discs  are  fairly  resistant  to  damage,  however 
mistracking can occur due to an accumulation of dirt on 
the disc surface. Follow the guidelines below for maximum 
enjoyment from your CD collection and player.
 
Do not write on either side of the disc, particularly the 
non-label  side  from  which  signals  are  read.  Do  not 
mark this surface.
 
Keep your discs away from direct sunlight, heat, and 
excessive moisture.
 
Always hold the CDs by the edges. Fingerprints, dirt, 
or water on the CDs can cause noise or mistracking. 
If a CD is dirty or does not play properly, clean it with 
a soft, dry cloth, wiping straight out from the centre, 
along the radius.
NO
YES
Correct
Maintenance
 
Cleaning the cabinet
Periodically  wipe  the  cabinet  with  a  soft  cloth  and  a 
diluted soap solution, then with a dry cloth.
Caution:
 
Do not use chemicals for cleaning (petrol, paint thinner, 
etc.). It may damage the cabinet.
 
Do not apply oil to the inside of the unit. It may cause 
malfunctions. 
Specifications
As part of our policy of continuous improvement, SHARP 
reserves  the  right  to  make  design  and  specification 
changes  for  product  improvement  without  prior  notice. 
The  performance  specification  figures  indicated  are 
nominal values of production units. There may be some 
deviations from these values in individual units.
 
General
Power source
AC 220 - 240 V ~ 50/60 Hz
Power 
consumption
Power on: 24 W
Power stand-by: 0.4 W (*)
Speaker
1-way speaker system
Speaker: 10 cm (4”) - 6 ohms - Full 
Range
Speaker 
maximum input 
power
50 W/channel
Speaker rated 
input power
25 W/channel
Frequency band 2.400GHz - 2.480GHz
Compatible 
Bluetooth Profile
A2DP (Advanced Audio Distribution 
Profile), AVRCP (Audio/Video 
Remote Control Profile)
Bluetooth 2.1 +EDR
Specifications (continued)
Dimensions
Width: 475 mm (18 - 11/16”)
Height: 191 mm (7 - 1/2”)
Depth: 83 mm (3 - 1/4”)
Weight
2.45 kg (5.4 lbs.)
( * )  This  power  consumption  value  is  obtained  when  the 
demonstration  mode  is  cancelled  in  the  power  stand-by 
mode. Refer to page 5 to cancel the demonstration mode.
 
Amplifier
Output power
PMPO: 100 W
MPO: 50 W (25 W + 25 W) 
(10% T.H.D.)
RMS: 50 W (25 W + 25 W) 
(10% T.H.D.)
RMS: 40 W (20 W + 20 W) 
(1% T.H.D.)
Output terminals Headphones: 16 ohms 
(recommended: 32 ohms)
Input terminals
Audio In (audio signal):
500 mV/47 k ohms
 
CD player
Type
Single disc multi-play compact disc 
player
Signal readout
Non-contact, 3-beam
semiconductor laser pickup
D/A converter
Multi bit D/A converter
Frequency 
response
20 - 20,000 Hz
Dynamic range
90 dB (1 kHz)
 
USB (MP3 / WMA)
USB host 
interface
Complies with USB 1.1 (Full 
Speed)/2.0 Mass Storage Class.
Support Bulk only and CBI 
protocol.
Support file
MPEG 1 Layer 3
WMA (Non DRM)
Bitrate support
MP3 (32 ~ 320 kbps)
WMA (64 ~ 160 kbps)
Other
Maximum total number of MP3/
WMA files is 65025.
Maximum total number of folders is 
999 INCLUSIVE of root directory.
The ID3TAG information supported 
are TITLE, ARTIST and ALBUM only.
Supports ID3TAG version 1 and 
version 2.
File system 
support
Support USB devices with 
Microsoft Windows/DOS/FAT 
12/FAT 16/ FAT 32.
2 kbyte block length for sector.
 
Tuner
Frequency range FM: 87.5 - 108 MHz
AM: 522 - 1,620 kHz
Preset
40 (FM and AM station)