Alliance Laundry Systems TMB795C User Manual

Installation

M414905

9. Place front panel on machine, loosely attach four

bottom screws. Connect door switch harness to

switch in new location. Install door assembly and

four front panel side screws loosely. Refer to

10. Check lint panel fit, adjusting front panel up or

down as required. Tighten four front panel side

screws to maintain position of front panel for

proper lint panel clearance.

11. Remove lint panel. Fully tighten bottom screws

on front panel.

12. Reinstall top screws and guide lugs.
13. Adjust door catch if necessary to allow

7 – 15 pounds pull (0.48 – 1.03 bar) at center of

handle.

14. Reinstall control assembly using mounting

screws.

15. Reinstall control panel and lint panel.

IMPORTANT: Restore power to tumbler and test

for proper operation of loading door switch.

Tumbler should not start with door open; an

operating tumbler should stop when door is

opened.

NOTE: If machine is converted back to right hand

hinge operation, the door switch harness must be

rerouted and rebundled with the lint panel switch

harness. Wire ties must be used to secure harnesses.

Wire ties (Part No. 55881) can be ordered from

RSPC.

Figure 9

TMB1997N

Switch (New location)

Plug (New location)

Door Assembly

Side Screw

TMB1997N