Haier RDE350AW User Manual

19

1.   Place the dryer in its Þ nal location. Take care not to crush or kink the exhaust 

vent.  Make sure that all four feet are Þ rmly in contact with the ß oor and that the 

dryer rests solidly in position.

NOTE: For a gas dryer, make sure that there are no kinks in the ß exible gas line.

2.   Using a carpenter’s level, check to make sure the dryer is level from side to side 

and from front to back.

3.   If the dryer is not level, adjust the leveling feet. Turn clockwise to extend (raise 

the dryer) or counterclockwise to retract (lower the dryer).

1.   Plug the dryer power cord into an appropriate outlet.

2.   Resume power to the outlet.  Check to make sure the circuit breaker is switched 

on.

3.   Dispose of/recycle all packaging materials.

4.   Make sure the dryer area is clean and free from combustible materials, gasoline, 

and other ß ammable vapors. Also see that nothing (such as boxes, clothing, etc.) 

obstructs the ß ow of combustion and ventilation air through the louvered panel 

located on the rear of the dryer.

5.   Test dryer operation by selecting a Timed Dry heated cycle. See the “Operating 

Instructions” section.

NOTE: On gas dryers, before the burner will light, it is necessary for the gas line to 
be bled of air. If the burner does not light within 45 seconds, the Þ rst time the dryer 

is turned on, the safety switch will shut o   the burner. If this happens, turn the dryer 
to “OFF” and wait 5 minutes before making another attempt to light the burner.