Frigidaire 137153700B User Manual

Page of 36
7
FRONT CONSOLE
MINIMUM INSTALLATION CLEARANCES - Inches (cm)
SIDES
REAR
TOP
FRONT
 Alcove
0” (0 cm) 0” (0 cm)
0” (0 cm)
n/a
 Under-
 Counter*
0” (0 cm) 0” (0 cm)
0” (0 cm)
1” (2.5 cm)
 Closet
0” (0 cm) 0” (0 cm)
0” (0 cm)
1” (2.5 cm)
REAR CONSOLE
MINIMUM INSTALLATION CLEARANCES - Inches (cm)
SIDES
REAR
TOP
FRONT
 Alcove
0” (0 cm) 0” (0 cm) 16” (40.5 cm)
n/a
 Under-
 Counter
n/a
n/a
n/a
n/a
 Closet
0” (0 cm) 0” (0 cm) 16” (40.5 cm)
1” (2.5 cm)
Clearance requirements
60 sq. in.
(387.1cm²)
3”
(7.6cm)
60 sq. in.
(387.1cm²)
3”
(7.6cm)
INSTALLATION IN A RECESS OR CLOSET
1.  A dryer installed in a bedroom, bathroom, recess or closet, 
MUST be exhausted outdoors.
2.  No other fuel burning appliance shall be installed in the 
same closet as the gas dryer.
3.  Your dryer needs the space around it for proper 
ventilation.
DO NOT install your dryer in a closet with a solid door.
4.  Closet door ventilation required: A minimum of 120 
square inches (774.2 cm²) of opening, equally divided at 
the top and bottom of the door, is required. Openings 
should be located 3 inches (7.6 cm) from bottom and top 
of door. Openings are required to be unobstructed when 
a door is installed. A louvered door with equivalent air 
openings for the full length of the door is acceptable.
closet door
 - EXPLOSION HAZARD - Do not install the 
dryer where gasoline or other fl ammables are kept or stored. 
If the dryer is installed in a garage, it must be a minimum 
of 18 inches (45.7 cm) above the fl oor. Failure to do so can 
result in death, explosion, fi re or burns.
 DO NOT INSTALL YOUR DRYER:
In an area exposed to dripping water or outside weather 
1. 
conditions.
In an area where it will come in contact with curtains, 
2. 
drapes, or anything that will obstruct the fl ow of com-
bustion and ventilation air.
On carpet. Floor MUST be solid with a maximum slope of 
3. 
1 inch (2.54 cm).
0”
(0 cm)
0”
(0 cm)
0”
(0 cm)
0”
(0 cm)
0”
(0 cm)
1”
(2.5 cm)
0”
(0 cm)
16”
(40.5 cm)
1”
(2.5 cm)
0”
(0 cm)
*For under-counter installation, top panel must be removed 
and kit number 131629100 must be installed. Kit is available 
from an authorized parts distributor.