Frigidaire 137153700B User Manual
8
The following are specifi c requirements for proper and safe
electrical installation of your dryer. Failure to follow these
instructions can create electrical shock and/or a fi re hazard.
electrical installation of your dryer. Failure to follow these
instructions can create electrical shock and/or a fi re hazard.
Electrical installation
Front Console Dimensions
Rear Console Dimensions
- ELECTRICAL SHOCK HAZARD -
This appliance MUST be properly grounded. Electrical
•
shock can result if the dryer is not properly grounded. Fol-
low the instructions in this manual for proper grounding.
low the instructions in this manual for proper grounding.
Do not use an extension cord with this dryer. Some ex-
•
tension cords are not designed to withstand the amounts
of electrical current this dryer utilizes and can melt, creat-
ing electrical shock and/or fi re hazard. Locate the dryer
within reach of the receptacle for the length power cord
to be purchased, allowing some slack in the cord. Refer
to the pre-installation requirements in this manual for the
proper power cord to be purchased.
of electrical current this dryer utilizes and can melt, creat-
ing electrical shock and/or fi re hazard. Locate the dryer
within reach of the receptacle for the length power cord
to be purchased, allowing some slack in the cord. Refer
to the pre-installation requirements in this manual for the
proper power cord to be purchased.
- ELECTRICAL SHOCK HAZARD -
A U.L.-approved strain relief must be installed onto pow-
•
er cord. If the strain relief is not attached, the cord can be
pulled out of the dryer and can be cut by any movement
of the cord, resulting in electrical shock.
pulled out of the dryer and can be cut by any movement
of the cord, resulting in electrical shock.
Do not use an aluminum wired receptacle with a copper
•
wired power cord and plug (or vice versa). A chemical
reaction occurs between copper and aluminum and can
cause electrical shorts. The proper wiring and receptacle
is a copper wired power cord with a copper wired recep-
tacle.
reaction occurs between copper and aluminum and can
cause electrical shorts. The proper wiring and receptacle
is a copper wired power cord with a copper wired recep-
tacle.
Dryers operating on 208 volt power supply will have
longer drying times than dryers operating on 240 volt power
supply.
supply.
2 9/16”
(6.5 cm)
4 3/8”
(11 cm)
4 3/8”
(11 cm)
3 3/4”
(9.5 cm)
3 3/4”
(9.5 cm)
27” (68.6 cm)
27” (68.6 cm)
2 9/16”
(6.5 cm)
1”
(2.5 cm)
1”
(2.5 cm)
13 1/2”
(34.4 cm)
13 1/2”
(34.4 cm)
3 3/4”
(9.5 cm)
3 3/4”
(9.5 cm)
36”
(91.5 cm)
36”
(91.5 cm)
43 5/8”
(111 cm)
34 5/8”
(87.9 cm)
electrical supply on rear of unit,
power cord length on gas unit
approximately 59” (150 cm)
to center of
rear vent
to center of
rear vent
gas supply pipe on
rear of gas unit
47 1/2” (120.7 cm)
to clear open door
47 1/2” (120.7 cm)
to clear open door
optional vent
knockout
optional vent
knockout
gas supply pipe on
rear of gas unit
center line
height for
rear vent
center line
height for
rear vent
under-counter
installation height
electrical supply on rear of unit,
power cord length on gas unit
approximately 59” (150 cm)