ARRI 416 User Manual

The camera can be inched by pressing the “PHASE” button 

while the camera is in Standby. If the “PHASE” button is only 

pressed briefly, the mirror shutter rotates a part revolution 

to enable an unrestricted view of the film gate (e.g. for 

checking the gate). If the “PHASE” button is held pressed 

longer, the camera will inch forward at approximately 1 fps. 

During inching the upper line of the display indicates the 

measured shutter angle, the lower line the measured 

voltage of the power supply.

The currently set operational parameters on the ARRIFLEX 416 

are displayed on the camera display 

a

 in various 

modes. The desired mode is selected via the “MODE” button. 

In each mode the corresponding operational parameters 

can be set using the “SEL” and “SET” buttons 

a

.

Note: 

The Mode numbers are shown in the display 

between the upper and the lower line. Mode 1 

is also indicated 

a

 in the display by a 

black horizontal bar.

To prevent an unintentional alteration of the operational 

parameters the buttons “SEL”, “SET”, and “PHASE” can be 

locked using the “LOCK” button. If a button is pressed when 

the display is locked, the display will show the “OFF” sign. 

If the display is locked, this is indicated by the “LOCK” 

symbol in the display.

Note: 

Locking the “PHASE” button has no influence 

on the inching function.