JVC 0104-FO-ID-PJ User Manual

MasterPage: Advan_Heading0_Right

White LED Light can be used to brighten the subject in 
the dark place during video recording or D.S.C. shooting.

Press LIGHT repeatedly to change the setting.

OFF: Turns off the light.
ON: The light is on always. (

 appears.)

AUTO: The light turns on automatically when dark. 
(

 appears.)

Press the Recording Start/Stop Button to start video 

recording or SNAPSHOT to shoot a still image.

● Be careful not to point the LED Light directly to eyes.

● If the light does not reach the subject, the Night-Alive 

function will be activated, and makes it possible to shoot 
the subject brighter.

● There is a difference in the brightness of the images shot 

between the centre area which is illuminated by the LED 
Light and the surrounding areas (which will be darker).

● Since subjects are shot at a reduced shutter speed when 

the White LED Light setting is “ON”, they will appear slightly 
blurred.

Makes dark subjects or areas even brighter than they 
would be under good natural lighting. Although the 
recorded image is not grainy, it may look as if it is 
strobing due to the slow shutter speed.

Set the Power Switch to “M” while pressing down the 

Lock Button located on the switch.

Open the LCD monitor fully. (

Press NIGHT so that the Night-Alive indicator “

” 

appears.

● The shutter speed is automatically adjusted to provide up to 

30 times sensitivity.

● “ ” appears beside “

” while the shutter speed is being 

automatically adjusted.

To deactivate Night-Alive
Press NIGHT again so that the Night-Alive indicator 
disappears.

● During Night-Alive, the following functions or settings 

cannot be activated and its indicator blinks or goes out:
• Some modes of “Program AE With Special Effects” 

• “GAIN UP” in CAMERA Menu. (

• “DIS” in MANUAL Menu. (

● During Night-Alive, it may be difficult to bring the camcorder 

into focus. To prevent this, use of a tripod is recommended.

GR-D94US.book  Page 29  Monday, November 17, 2003  2:12 PM