SVAT Electronics CLEARVU4 User Manual

now you can see

CLEARVU4

14

You can use these settings to adjust the area and sensitivity of motion detection on 

each camera channel. These settings are important if you are using motion activated 

recording, because if adjusted correctly, they can help prevent false triggering of 

motion recording.

1.  Channel – Select the camera channel in which you would like to make changes

2.  Set Detection Area – Select this setting to enter a grid screen for the selected 

camera channel. In this screen you can set the areas in the camera’s view 
that you want to enable or block motion detection in. For example, if there 

are  cars  constantly  driving  by  in  an  area  on  your  camera,  you  can  block 

that area from detecting motion. Use the directions below to set up motion 
detection areas:

• 

Grey: Detection Block. These areas will be detected

• 

Transparent: Non-Detection Block. 

• 

Green: Flashes when motion on the camera is being detected.

Use the green flashes to determine where motion is consistently being detected, and 
then make sure to set the motion detection area to exclude these areas from motion 
detection. Follow the directions below:

• 

Press “SEARCH” button to enable whole detection area. 

• 

Press “MENU” button to disable whole detection area. 

• 

You can set up a maximum of 3 separate detection areas (Detection areas  
may overlap):

• 

Press the” UP/ DOWN/ LEFT/ RIGHT” buttons to setup the starting point of 
the detection area.

• 

Press the “ENTER” button to confirm the starting point of the detection area.