Panasonic DMC-L10K User Guide

128

VQT1G28

You can use the camera without worrying 
about battery discharge when it is 
connected to a PC or a printer if you use 
the DC cable (DMW-DCC1; optional) to 
connect the camera to the battery charger/
AC adaptor (supplied) and connect the AC 
cable.
• Check that the camera is turned off.
• Close the flash.

2 Connect the DC cable A.

• Pull open the DC cable cover 

1 and 

then connect the DC cable to the 
camera body using the same steps as 
“Inserting/Removing the Battery” (P21). 
Pull the DC cable through the opening 
as shown in the illustration and then 
close the battery door.

• Be careful not to catch the DC cable 

when closing the battery door.

• You cannot charge the battery if you 

connect the DC cable (DMW-DCC1; 
optional).

• Be sure to use the supplied AC cable and 

the prescribed DC cable (DMW-DCC1; 
optional) when using the battery charger/
AC adaptor (supplied) as an AC adaptor.

• The camera becomes warm during use. 

This is not a malfunction.

• Disconnect the charger/AC adaptor and 

DC cable when the camera is not in use.

• The unit is in the standby condition when 

the AC adaptor is connected. The primary 
circuit is always “live” as long as the AC 
adaptor is connected to an electrical 
outlet.

1

A

VQT1G28ENG_L10KP.book  128 ページ  ２００７年９月６日　木曜日　午前９時２９分