Panasonic DMC-LZ3 User Manual
Connecting to other equipment
80
VQT0U87
Connecting to other equipment
Connecting to a PC
You can acquire recorded pictures to a PC
by connecting the camera and the PC.
The software [LUMIX Simple Viewer]
(for Windows
by connecting the camera and the PC.
The software [LUMIX Simple Viewer]
(for Windows
®
) in the CD-ROM (supplied)
allows you to easily acquire pictures
recorded with the camera to a PC, print
them and send them by e-mail.
If you use Windows
recorded with the camera to a PC, print
them and send them by e-mail.
If you use Windows
98/98SE, install the
USB driver and then connect it to the
computer.
For information about installing [LUMIX
Simple Viewer] etc., refer to the separate
operating instructions for PC connection.
computer.
For information about installing [LUMIX
Simple Viewer] etc., refer to the separate
operating instructions for PC connection.
A: USB connection cable (supplied)
B: AC adaptor (DMW-AC6; optional)
• Use batteries with sufficient battery power
B: AC adaptor (DMW-AC6; optional)
• Use batteries with sufficient battery power
or the AC adaptor (DMW-AC6; optional).
• Turn the camera off before inserting or
removing the cable for the AC adaptor
(DMW-AC6; optional).
(DMW-AC6; optional).
1 Turn on the camera and the PC.
2 Connect the camera to a PC via
the USB connection cable
A
(supplied).
• Connect the USB connection cable with
the [
] mark facing the [
1] mark on
the [DIGITAL] socket.
• Hold the USB connection cable at
C
and insert straight in or take straight
out. (If you forcibly insert the USB
connection cable at a slant or upside
down you can deform the connection
terminals and damage the camera or
the connected equipment.)
out. (If you forcibly insert the USB
connection cable at a slant or upside
down you can deform the connection
terminals and damage the camera or
the connected equipment.)
D: This message appears during data
transfer.
3 Press
3 to select [PC] and then
press [MENU/SET].
• If you set [USB MODE] in the [SETUP]
menu to [PC] in advance, it is not
necessary to set this every time you
connect to a PC. (P23)
necessary to set this every time you
connect to a PC. (P23)
• If you set [USB MODE] to [PictBridge
(PTP)] and then connect the camera to
the PC, messages may appear on the
screen of the PC.
Select [Cancel] to close the messages
and disconnect the camera from the
PC. Set [USB MODE] to [PC] again.
the PC, messages may appear on the
screen of the PC.
Select [Cancel] to close the messages
and disconnect the camera from the
PC. Set [USB MODE] to [PC] again.
[Windows]
The drive appears in the [My Computer]
folder.
The drive appears in the [My Computer]
folder.
SCN
1
SCN
2
DIGITAL
AV OUT
DC IN 3V
DC IN 3V
ACCESS
USB MODE
SELECT
SET
MENU
MENU
SET
PictBridge(PTP)
PC
PLEASE SELECT
THE USB MODE
THE USB MODE
VQT0U87ENG.book 80 ページ 2005年12月27日 火曜日 午後7時12分