Casio EX-ZR200 User Manual
114
Viewing Snapshots and Movies
3.
Press [p] (PLAY) to turn on the camera.
This will cause an image to appear on the TV screen, without anything appearing
on the camera’s monitor screen.
on the camera’s monitor screen.
• Pressing [ON/OFF] (Power) or [r] (REC) will not turn on the camera while the
AV cable is connected.
• You also can change the aspect ratio of the screen and the video output
4.
Now you can display images and play back movies as you normally do.
IMPORTANT!
• Before connecting to a TV to display images, be sure to configure the camera’s
[r] (REC) and [p] (PLAY) buttons for “Power On” or “Power On/Off” (page 166).
• Audio is initially output by the camera at maximum volume. When you first start
displaying images, set the TV volume control at a relatively low level and then
adjust it as required.
adjust it as required.
NOTE
• Audio is stereo.
• Some TVs may not be able to output images and/or audio correctly.
• All icons and indicators that appear on the monitor screen also appear on the TV
• Some TVs may not be able to output images and/or audio correctly.
• All icons and indicators that appear on the monitor screen also appear on the TV
screen. You can use [8] (DISP) to change the display contents.
• Normally connecting the camera to a TV during recording will cause the camera’s
monitor screen to go blank and display the image picked up by the camera on the
TV screen. If you are using Wide Shot (page 78), the image will be shown on the
monitor screen but not the TV screen. Image recording can be performed in either
case.
TV screen. If you are using Wide Shot (page 78), the image will be shown on the
monitor screen but not the TV screen. Image recording can be performed in either
case.