Panasonic AJ-HPX3100G User Manual
111
Preparation: Mounting the Lens and Performing the Flange Back and White Shading Adjustments
P
reparati
o
n
1
Raise the lens clamping lever and remove the
mount cap.
mount cap.
2
To mount the lens, align the indentation at the
top center of the lens mount with the center
mark of the lens.
top center of the lens mount with the center
mark of the lens.
3
Lower the lens clamping lever to clamp the lens.
4
Secure the cable through the cable clamp, and
plug it into the LENS connector.
plug it into the LENS connector.
5
Adjust the lens flange back.
Notes
z
Please refer to the lens instruction manual for guidance
on lens handling.
on lens handling.
z
When the lens is removed, install the mount cap to
protect the device.
protect the device.
If images are not clearly focused at both telephoto and wide-
angle positions during zoom operations, adjust the flange
back (distance from the lens mounting surface to the image
formation surface).
Once adjusted, the flange back does not need to be re-
adjusted as long as the same lens is mounted on the camera.
angle positions during zoom operations, adjust the flange
back (distance from the lens mounting surface to the image
formation surface).
Once adjusted, the flange back does not need to be re-
adjusted as long as the same lens is mounted on the camera.
Note
Please also refer to the lens instruction manual for directions
on adjustment and locations of individual lens parts.
on adjustment and locations of individual lens parts.
1
Mount the lens on the camera.
Make sure you connect the lens cable.
2
Set the lens iris to manual, and fully open the iris.
3
Place the flange back adjustment chart about
3 m from the lens and adjust the lighting on
the chart to obtain an appropriate video
output level.
3 m from the lens and adjust the lighting on
the chart to obtain an appropriate video
output level.
If the video level is too high, use the filters or the
shutter.
shutter.
4
Loosen the F.f (Flange focus) ring clamping
screw.
screw.
Note
F.b (Flange back) may be indicated on some lenses.
5
Set the zoom ring to the telephoto position,
either manually or by electric drive.
either manually or by electric drive.
6
Aim the lens at the flange back adjustment
chart and turn the distance ring to bring the
chart into focus.
chart and turn the distance ring to bring the
chart into focus.
7
Set the zoom ring to the wide-angle position
and turn the F.f ring to bring the chart into
focus.
and turn the F.f ring to bring the chart into
focus.
While focusing, take care not to move the distance ring.
Mounting the Lens and Performing the Flange Back
and White Shading Adjustments
Mounting the Lens
Lens Clamping
Lever
Lever
Mount Cap
Mark
LENS Connector
Adjusting the Lens Flange Back
Approximately 3m
AJ-HPX3100G(VQT3A79)_E.book 111 ページ ２０１０年９月１７日 金曜日 午後９時２１分