Panasonic HDC-DX1PC User Manual
31
LSQT1093
Setup
Setup
Charging the battery
When this unit is purchased, the battery is not
charged. Charge the battery before using this
unit.
≥If the DC cable is connected to the AC
charged. Charge the battery before using this
unit.
≥If the DC cable is connected to the AC
adaptor, then the battery will not charge.
Remove the DC cable from the AC adaptor.
Remove the DC cable from the AC adaptor.
≥The Panasonic battery that can be used
with this unit is VW-VBG260. Other
Panasonic batteries will not work. (l 32)
Panasonic batteries will not work. (l 32)
1
Connect the AC cable to the AC
adaptor and the AC outlet.
adaptor and the AC outlet.
≥Remove the DC cable beforehand.
2
Put the battery on the battery
mount by aligning the mark, and
then securely plug it in.
mount by aligning the mark, and
then securely plug it in.
≥The output plug of the AC cable is not
completely connected to the AC adaptor
jack. As shown in A, there is a gap.
jack. As shown in A, there is a gap.
ª Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: Make sure that the terminals of the
Goes off: Charging completed
Flashing: Make sure that the terminals of the
battery or the AC adaptor are not
exposed to dirt, foreign objects or
dust, then reconnect them properly.
Disconnect the AC cable from the AC
outlet when you remove dirt, foreign
objects or dust on the terminals of the
battery or the AC adaptor.
If the charging lamp is still flashing,
something may be wrong with the
battery or AC adaptor. Contact your
dealer.
exposed to dirt, foreign objects or
dust, then reconnect them properly.
Disconnect the AC cable from the AC
outlet when you remove dirt, foreign
objects or dust on the terminals of the
battery or the AC adaptor.
If the charging lamp is still flashing,
something may be wrong with the
battery or AC adaptor. Contact your
dealer.
≥Battery charging time (
l 32)
≥We recommend using Panasonic batteries
(VW-VBG260).
≥If you use other batteries, we cannot guarantee
the quality of this product.
Fitting/Removing the battery
Push the battery against the battery
holder and slide it until it clicks.
holder and slide it until it clicks.
While sliding the BATT lever, slide
the battery to remove it.
the battery to remove it.
≥Hold the battery with your hand so it does not
fall.
≥Before removing the battery, be sure to set the
Mode dial to OFF and check that the status
indicator is off.
indicator is off.
A
Fitting the battery
Removing the battery
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
LSQT1093ENG.book 31 ページ ２００７年１月１５日 月曜日 午前９時２３分