Pelco C2910M-A (4/05) User Manual

 

C2910M-A (4/05)

13

 

The CCC5100H Series camera combines data, video, and power leads into a single multifunction connector on the rear panel. This lets you 
quickly install and uninstall the camera.

The camera supports two different RJ-45 plugs, depending on the application. Use a 10-pin RJ45-10 plug. (The 10-pin RJ45-10 plug is also 
known as an RJ-50 plug.) If you will not use camera control to access the on-screen menus, you can use an 8-pin RJ-45 plug.

To install the multifunction connector, you will need the following:

 

Unshielded twisted pair cable, either 10-conductor in five twisted pairs or 8-conductor in four twisted pairs. If you will not implement UTP 
video, you can use flat Cat5 or Cat6 cable.

 

RJ45-10 (10-pin) or RJ-45 (8-pin) plugs

 

A crimping tool that matches the plug type: RJ45-10 (10-pin, 10-conductor) or RJ-45 (8-pin, 8-conductor)

Next, identify the multifunction connector leads that you will use.

Wire the cable and connectors according to Table C. Figure 5 identifies pin 1 on the multifunction connector.

Finally, plug the multifunction connector into the camera. Each pair of leads is described in more detail in 

 

 and 

 

Multifunction Connector

 

Multifunction Connector, Pin 1

 

Do not connect a network cable into the multifunction connector on the camera’s rear panel. It is 

 

 a network connector.

 

The PCM150 camera mount is designed for the CCC5100H Series camera. It includes a preconfigured cable and an easy-to-wire 
adapter plate.

 

1

Pelco Data RX+ 

1

Pelco Data RX+ 

2

Coax Video Return 

10

Pelco Data RX-

3

Coax Video 

3

Coax Video 

4

Reserved 

2

Coax Video Return 

5

UTP- Video 

6

UTP+ Video 

6

UTP+ Video 

5

UTP- Video 

7

Reserved 

9

12 V  

 / 24 V 

 

8

GND 

 / 24 V 

 

8

GND  

 / 24 V 

 

9

12 V  

 / 24 V 

 

4

Reserved 

10

Pelco Data RX-

7

Reserved 

PIN 1