Pelco C2910M-A (4/05) User Manual

 

14

C2910M-A (4/05)

 

The CCC5100H Series camera lets you access and configure the menu settings from any Pelco keyboard, receiver, or other device that supports 
the Pelco D or Pelco P protocol. The camera supports the following settings:

 

Baud rate:

2400, 4800, 9600

 

Start bit:

1

 

Data bits:

8

 

Stop bit:

1

 

Parity:

None

 

Device Transmit (TX) to Camera Receive (RX) Connections

 

Connect the coax video wires to the multifunction connector (refer to Table E). Refer to Table B for the maximum video cable distance (BNC).

 

Coax Video Connections

 

The CCC5100H Series camera supports composite video over unshielded twisted pair (UTP) cabling. The camera UTP video output signal is 
1 Vp-p differential into a 100-ohm load.

At a minimum, UTP requires Cat5, 100-ohm twisted pair cable. You can install either a passive or an active UTP receiver at the head-end. Table F 
lists the maximum UTP wiring distances. It also lists the restrictions when using either type of UTP receiver.

 

UTP Wiring Distances

 

 

UTP Video Connections

 

1

Pelco Data RX+

TX+

10

Pelco Data RX-

TX-

 

  To use the control leads, you must use an RJ45-10 plug.

 

2

Coax Video Return

3

Coax Video

 

The CCC5100H Series camera supports video to both active and passive UTP receivers. However, Coaxitron and Pelco V-Sync are 

only supported when using a passive UTP receiver. Refer to 

 

 for information about Coaxitron and Pelco V-Sync.

 

Active

(Video Only)

0-3,000 ft

(0-914.4 m)

Passive

(Video, Coaxitron, 

Pelco V-Sync)

0-750 ft

(0-228.6 m)

 

5

UTP- Video

6

UTP+ Video