Sony DXC-D35 User Manual
3-5
DXC-D35/D35WS(UC)
DXC-D35P/D35WSP(CE) V1
3-2. Before Adjustment
3-2-1. Color Bar Signal Confirmation
Equipment:
Waveform monitor, Vectorscope
Preparation:
OUTPUT/DL/DCC+ switch: BARS
Test point:
VIDEO OUT connector
Specification:
[for NTSC]
[for PAL]
. Chroma Level
Confirm that the beam spots of each color (R, Y
L
, G, C
Y
,
G, B and M
G
) are inside the area “
4”.
[for NTSC]
[for PAL]
m
. Partial difference between scale and signal level is
. Partial difference between scale and signal level is
caused by photographic error.
. If the specifications are not met, carry out from “3-3-2.
INT SC Phase Adjustment” through “3-3-9. Chroma
(YC) Level Adjustment”.
. Use the vectorscope conforming to setup “7.5 IRE”. (for
NTSC)
R
M
G
B
C
Y
G
Y
L
R
M
G
C
Y
G
Y
L
B
Burst Spot 75%
Burst Spot 75%
3-2-2. Sensitivity Measurement Confirmation
Object:
Overall white
Light:
3200K, 2000 lux
(If the pattern box is used, set the
AUTO mode)
(If the pattern box is used, set the
AUTO mode)
Equipment:
Waveform monitor
Preparation:
. Shoot the overall white pattern covering fully the
monitor frame.
. Lens iris
→
F11
. OUTPUT/DL/DCC + switch: CAM/DCC +
. W. BAL switch: PRESET
n
If the zoom position is at the “TELE” edge, F value of the
camera may decrease. When decreasing, adjust the dis-
tance between the pattern box and the camera and bring the
zoom position slightly from the “TELE” edge to “WIDE”.
. W. BAL switch: PRESET
n
If the zoom position is at the “TELE” edge, F value of the
camera may decrease. When decreasing, adjust the dis-
tance between the pattern box and the camera and bring the
zoom position slightly from the “TELE” edge to “WIDE”.
Specification:
100
±
10 IRE (for NTSC)
700
±
70 mV (for PAL)
[for NTSC]
[for PAL]
n
If the specification is not met, perform “3-3-11. CCD OUT
If the specification is not met, perform “3-3-11. CCD OUT
Level Adjustment”.
3-2. Before Adjustment