Sony EVI-H100S User Manual

47

The D70 mode allows you to control the EVI-H100S/

H100V using VISCA commands for the EVI-D70/P.

Most of the VISCA commands for the EVI-H100S/

H100V correspond to one for the EVI-D70/P. However,

some of the VISCA commands for the EVI-H100S/

H100V are different from those for the EVI-D70/P in

definitions of parameters.

When you send those commands to an EVI-H100S/

H100V whose D70 mode is set to ON, the camera

translates the parameters for the EVI-D70/P to those

for the EVI-H100S/H100V and executes the command.

The following parameters are subject to translation.



 Zoom position



 Pan-tilt speed



 Pan-tilt position



 Even if you set the D70 mode to ON, the EVI-

H100S/H100V may not emulate the EVI-D70/P

perfectly. This is caused by differences in hardware

between the two models.



 The functions that are provided with the EVI-D70/

P but not with the EVI-H100S/H100V cannot be

executed.

You can switch the D70 mode ON or OFF by switching

the BOTTOM switch at the bottom of the EVI-H100S/

H100V. To change the D70 mode setting, move the

BOTTOM switch to ON or OFF while the camera’s

power is off or the camera is in standby mode. Then,

turn the power on by connecting the camera to an AC

outlet or by using the VISCA commands or the Remote

Commander.

It takes about 7-16 seconds for the image to be

displayed after Pan/Tilt initialization motion has

stopped.

Do not turn off DC power until the image has been

displayed.

The mode will not change if you change the switch

setting of the BOTTOM switch after the power has

been turned on.

After you change the mode, previously saved position

preset data will be lost. (Zoom, Pan/Tilt positions, etc.

will be reset to their initial settings.)