Panasonic WV-CW504S User Manual

21

Performs the settings relating to the camera system such as synchronization, alarm input/output terminal, and privacy zone. 
The following settings can be configured on the "SYSTEM SETUP" screen displayed from the top screen. Refer to page 5 for how to 
call up the screen. 

This unit supports the following 3 types of synchronization methods, and one of the following is selected. 
 (1)  Multiplexed vertical drive signal (VD2)
 (2)  Synchronization is performed on the basis of the power supply frequency. 
 (3)  Internal synchronization (INT) (default)
Input of a multiplexed vertical drive signal (VD2) automatically switches to the VD2 synchronization even if the camera is set to other 
than the VD2 synchronization method. 
When  other  than  the  VD2  synchronization  is  selected,  either  the  power  supply  synchronization  or  internal  synchronization  can  be 
selected. 

 •  The power supply synchronization (LL) setting is changeable only in the 60 Hz areas. The power supply synchronization (LL) can-

not be setup in the 50 Hz areas.

The adjusting video signal of the camera and the criterial external synchronizing input signal (power) are connected to a 2-input oscil-
loscope and the phase is adjusted. 

 •  Movement of the camera or presence of a spike noise in the power line may cause vertical phase change. In such a case, adjust

the phase again. 

Follow the procedure below. 

     

!0

!1

!2

!3

!5

!4

"SYSTEM SETUP" screen

"SYSTEM SETUP" screen

"SYNC" screen