Panasonic WV-CW504S User Manual

22

Set "SYNC" to "LL" and press the setting button. 
 

→  The "SYNC" screen appears. 

Connect the video output signal and external synchronizing input signal of the camera to a 2-input oscilloscope, and move the cursor 
to "COARSE". 

Adjust the oscilloscope to the vertical rate, and extend the vertical synchronizing part of the oscilloscope. 
Move the cursor horizontally with use of the right or left button to roughly adjust the vertical phase. 
The phase can be adjusted in 16 steps by 22.5 degrees. 
1 (1--16) : 0 °/2 (1--16) : 22.5 °/· · ·/16 (1--16) : 337.5

Move the cursor to "FINE", and fine adjust vertical phases. 

 •  When using WV-CW504F or WV-CW504S (with a Panasonic x2 varifocal lens), select "PANASONIC".
 •  When using WV-CW504FK or WV-CW504SK (with a lens other than Panasonic), select "OTHER".

When undesired portions in the camera shooting area (on the screen) exist, those portions (privacy zone) are hidden. Up to 8 portions 
can be specified for the privacy zone. 
ON (1): Grays the zone. 
ON (2): Mosaics the zone. 
OFF (default): Displays the zone normally. 
Follow the procedure below.

 •  The privacy zone function is disabled at initializing the unit, i.e. right after turning on the power.

Move the cursor to "PRIVACY ZONE", select "ON (1)" or "ON (2)", and press the setting button. 
 

→  The zone setting screen appears. 

Move the cursor to the number at the right of the title and select the zone number using the right or left button. 

"SYSTEM SETUP" screen

Zone setting screen