Avaya 03-300430 User Manual

ABRT

Internal system error

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

2000

ABRT

Response to the test was not received within the allowable time period. This 

may be due to hyperactivity. Error type 1538 in the error log indicates 

hyperactivity. The hyperactive circuit pack is out of service and one or more 

of the following symptoms may be exhibited.

●

The DS1-BD tests (such as test 138 and test 139) are aborting with 
error code 2000.

●

The tests run on the ports of this circuit pack are returning a no board 
result.

●

A busyout or a release has no affect on the test results.

●

A list config shows that the circuit pack and the ports are 

properly installed.

When hyperactivity occurs, the circuit pack is isolated from the system, and 

all of its trunks are placed into the out-of-service state. The system will try to 

restore the circuit pack within 15 minutes. When no faults are detected for 

15 minutes, the DS1 interface circuit pack is restored to normal operation. 

Every DS1 interface trunk is then returned to the in-service state. 

Hyperactivity is often caused by the associated facility. In such a case, faults 

(such as slips, misframes, or blue alarms) would be entered in the error log. 

In addition, many hardware errors would be logged against the associated 

trunk circuits. If the facility is OK and the error occurs again after 15 minutes, 

escalate this problem.

FAIL

DS1 Interface circuit pack failed the DS1 Board Loopback test.

1. Retry test ds1-loop location ds1/csu-loopback-tests.
2. If the BLB test continues to fail, then replace the DS1 circuit pack.

PASS

The BLB test executed successfully. The test pattern was transmitted and 

received successfully up to the TN767E DS1 board edge.

 2 of 3