Avaya 03-300430 User Manual

1113

FAIL

The signaling link has failed; the system cannot send any messages on 
behalf of this trunk.

1. Consult procedures for ISDN-SGR (ISDN-PRI Signaling Group) and 

ISDN-LNK (ISDN Signaling Link Port).

FAIL

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

PASS

Wait 4 minutes and then check the Error Log for any new errors of type 

3073. If there are none, then both sides of the ISDN connection agree on 

the service state; the negotiation succeeded. If there is a new 3073 error, 

then the negotiation failed (the far-end switch twice failed to respond within 

2 minutes). The switch will automatically retry every 15 minutes. If the trunk 

was initially in service, it is now placed in the maintenance/far-end state. 

Incoming calls will be accepted, but no outgoing calls can be originated. If 

an incoming call is presented, another Service State Audit will be 

immediately performed in an attempt to put the DS1 ISDN Trunk in the 

proper state.

Any

NO 

BOARD

The test could not relate the internal ID to the port (no board). This could be 

due to incorrect translations, no board is inserted, an incorrect board is 

inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute add ds1 

location to administer the MM710 interface if it is not already 

administered.
If the board was already administered correctly, check the error log to 

determine whether the board is hyperactive. If this is the case, the board is 

shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then enter 

busyout board location.

Enter reset board location.

Enter release board location.

Enter test board location long.

This should re-establish the linkage between the internal ID and the port.

 2 of 2