Avaya 03-300430 User Manual

7

ABRT

The port was seized by a user for a valid call.

1. Enter display port location to determine the station’s 

extension.  Enter status station extension to determine the 

service state of the port.  If the port is active, it will be unavailable for 
certain tests.  Wait until the port is idle before retesting.

2. If the port is idle, retry the command at 1-minute intervals up to 5 

times.

1000

ABRT

System resources required to run this test were not available.  The port 
may be busy with a valid call.  (This could be a Music-on-Hold port.)

1. Enter display port location to determine the station’s 

extension.  Enter status station extension to determine the 

service state of the port.  If the port is active, it will be unavailable for 
certain tests.  Wait until the port is idle before retesting.

2. If the port is idle, retry the command at 1-minute intervals up to 5 

times.

1002

ABRT

The system could not allocate time slots for the test.  The system may be 
under heavy traffic conditions or it may have time slots out-of-service due 
to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

repeat test at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test.  The system 
may be oversized for the number of Tone Detectors present or some Tone 
Detectors may be out-of-service.

1. Resolve TTR-LEV errors.

2. Resolve TONE-PT errors.

3. If neither condition exists, retry the test at 1-minute intervals up to 5 

times.

1004

ABRT

The port has been seized for a valid call during the conference or noise 
test.

1. If the circuit pack is a TN742 of Vintage 10 or less, this test is not valid.  

Otherwise, proceed with step 2.

2. When the port is available for testing, retry the command at 1-minute 

intervals up to 5 times.

 2 of 5