Avaya 03-300430 User Manual

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to ABORT with error code 2000, check for system 

powering problems with the PN’s A carrier.  Resolve every 
AC-POWER and CARR-POW alarm in a multicarrier-cabinet system or 
DC-POWER alarm in a single-carrier cabinet system.  Then, repeat the 
test.

3. If the test continues to ABORT with a 2000 error code, resolve any 

errors against the PN’s MAINT (Maintenance circuit pack).  Then, 
repeat the test.

2029,

2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

FAIL

AC-POWERED SYSTEMS
There is a problem with one or both OLSs on the tested carrier.

1. For each OLS that has every status LED OFF, check the AC input to 

the OLS at the OLS outlet.  If there is no AC, then check the 
appropriate fuses for the affected OLS.  Replace open fuses.  If the 
fuses open again or AC does not show up at the OLS outlet, then there 
is probably a power wiring problem in the cabinet.

2. At this point, AC should be present at the OLS outlet.  Use recycle 

carrier UUC  (where UUC is the appropriate cabinet and carrier) in 

an attempt to bring back the OLSs for this carrier.  If the test passes, 
the trouble is cleared.  If the test does not pass, one OLS or both, in 
the tested carrier is defective.  If only one OLS is defective, then the 
status LEDs on the healthy OLS will light green for a moment.  When 
the recycle test determines that both OLSs are defective, the software 
will turn off power to both the good and defective OLSs.  This will 
cause the status LED(s) on the good OLS to light red.

3. Unplug both OLSs, and wait approximately 1-minute to allow the OLSs 

to cool down.  Plug in the OLSs.  If either OLS is operating properly 
(the status LEDs show green), then replace the defective OLS(s).  See 
OLS Replacement Procedures in this section.

 2 of 5