Bosch D625 User Manual

D623 Series/D625 Series | User's Guide | Check System Status 

. 

 

Bosch Security Systems | 9/04 | 46841E 

9 

 

Check System Status 

When the system is Off, press [CMD] to show the 
current system status. The following message may 
appear: 

Table 4:  System Status Messages 

 

System Status 
Message 

Description 

System OK 

Indicates there are no system 
troubles. 

System Trouble! 
Press [4] to view 

Indicates there is a system trouble. 
Refer to Check System Troubles 
(Cmd 4) on page 20 to determine 
the nature of the trouble. 

Points faulted 
Press [0] to view 

Indicates the system has faulted 
points. Refer to View Faulted 
Points on page 15 for more 
information. 

Log Out of the System 

The system remembers passcodes entered for 
approximately 10 sec. after you stop pressing keys. To 
log out of the system, press the [CMD] key twice. 
Logged Out appears on the keypad display. 

Silence Alarms 

When an alarm occurs, the alarm tone sounds and the 
display shows the point(s) in alarm. If you enter your 
passcode before the system dials your security 
company, the alarm report is aborted. 
1.

 

The keypad displays the point(s) in alarm. 

 

2.

 

Enter your passcode to silence the alarm and turn 
the system off (if it was turned on). An alarm 
report is sent to your security company if the 
alarm is not acknowledged in time. 
The display continues to show the point (or 
points) that caused the alarm. 

 

3.

 

Press and hold [CMD] to remove the alarm 
messages from the keypad display. Refer to 
Section View Alarm Memory (Cmd 40) on page 21 to 
see which points caused the alarm.