Bosch D625 User Manual

D623 Series/D625 Series | User's Guide | Keypad Adjust (Cmd 49) 

 

 

10 

Bosch Security Systems | 9/04 | 46841E 

 

Keypad Adjust (Cmd 49) 

 

I can perform this command. 

 

I cannot perform this command. 

Use Command 49 to adjust the keypad sounder 
volume and the display brightness. 
1.

 

Press [CMD] [4] [9]. Enter a valid passcode if 
prompted. 

2.

 

To adjust the keypad sounder volume, press and 
hold the [*] key and then press [1] to increase the 
volume or [4] to decrease the volume. 

3.

 

To adjust the keypad display brightness, press and 
hold the [*] key and then press [3] to increase the 
brightness or [6] to decrease the brightness. 

4.

 

Press [CMD] to exit this command function when 
all adjustments are made. 

Turn the System Off 

Entry Delay Time (to be filled in by your security 
company). 

You have __________ sec. to enter premises and turn 
system off. 

Enter your passcode to turn the security system off. 
When the system is on, you must enter through a 
designated entry door to prevent an alarm. Opening a 
designated door, such as the Front Door, starts the 
entry delay. During entry delay time, the keypad emits 
a double tone to remind you to turn the system off. 
Enter your passcode before the entry delay time 
expires to turn the system off. 

If you enter through the wrong door or fail to turn the 
system off before the entry delay time expires, you may 
cause an alarm. If an alarm occurs, silence the alarm by 
entering your passcode and call your security company 
to let them know that there is no emergency situation. 
1.

 

When the system is on, the On indicator 
illuminates. If the system is All On, the keypad 
display shows: 

 

If the system is Part On, the keypad display 
shows (Part 2 On shows if the system is Part 2 
On): 

 

2.

 

Enter your passcode to turn the system off. Once 
the system is off and there are no faulted points, 
the keypad displays the idle text (second line) as 
shown below: 

 

Turn the System All On (All On 

or Cmd 1) 

Exit Delay Time (to be filled in by your security 
company). 

You have __________ sec. to exit premises before 
system turns on. 

Use this command to turn on the entire system. Once 
you press the [ALL ON] key or enter Cmd 1, the Exit 
Delay timer starts its countdown. The length of exit 
delay is programmed by your security company. 

When your system is ready to turn All On, it displays 

OK for All On

, indicating all points are normal, 

such as no open doors or windows and no one standing 
in front of a motion detector. 

 

If your keypad displays a message indicating the 
system is not ready to arm (such as 

Not Ready to 

Arm

), check all doors and windows to see if any are 

open or if someone or something is in front of a motion 
detector. If all protected doors and windows are closed 
and no motion detectors are blocked and the keypad 
still displays 

Not Ready to Arm

, contact your 

security company for assistance. 

In the example below, the exit delay is 60 sec. Leave 
before the exit time expires. Leaving after exit delay 
expires causes an alarm event. 
1.

 

Make sure all points are normal (not faulted). If 
your system has a faulted point (door/window 
open), you can either close it or bypass it (see 
Bypass Points 1 on page 18). 

2.

 

Press [ALL ON] or [CMD] [1]. The keypad may 
prompt you to enter a valid passcode.