Wayne-Dalton AND 9600 User Manual

Tools Needed:

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your 

local yellow pages/business listings or go to the 

Find a Dealer section online at www.Wayne-Dalton.com

Install the side lock on the second 
section of the door. secure the lock 
to the section with (4) 1/4”- 20 x 
11/16” self drilling screws. square the 
lock assembly with the door section 
and align with the square hole in the 
vertical track. The side lock should be 
spaced approximately 1/8” from the 
section edge.

IMPORTANT: sIDE lOCks MusT BE 

REMOVED OR MaDE INOPERaTIVE IN 

THE uNlOCkED POsITION If aN 

OPERaTOR Is INsTallED ON THE 

DOOR.

NOTE: after completing this step, 

continue with step 9 on page 15.

❉

(4) 1/4”- 20 x 11/16” 

sElf DRIllING sCREWs

1/8”

Power Drill

7/16” socket 

Driver

NOTE: When installing a DoorMaster

TM

 

operator use the center bracket and 

drive gear supplied with your operator 

(located in DoorMaster

TM

 package). 

slide the DoorMaster

TM 

bracket/drive 

gear assembly onto the TorqueMaster

®

 

spring tube, so that the drive gear/

center bracket assembly are in the 

center of the TorqueMaster

®

 spring 

tube. 
NOTE: after completing this step, 

continue with step 20 on page 24.

None

CENTER 

BRaCkET 

BusHING 

assEMBly

TORquEMasTER

®

 TuBE

DOORMasTER

TM 

 BRaCkET/ 

DRIVE GEaR assEMBly 

To locate the center bracket, mark the 
header halfway between the flagangles 
and level the TorqueMaster

®

 spring 

tube. Drill 1/8” pilot holes into header 
for the lag screws. fasten the metal 
bracket to the header using (2) 1/4” x 
1-1/2” lag screws.

NOTE: after completing this step, 

continue with step 28 on page 31.

Tools Needed:

Power Drill

1/8” Drill Bit

7/16” socket Driver

(2) 1/4” x 1-1/2” 

HEx HEaD laG 

sCREWs

❉