Vermont Casting 36XDV User Manual

9

The EB-1 Electrical junction box has been fitted stand-
ard on this model to allow for the easy connection of an 
optional fan kit. 
To connect the EB-1 box to the house electrical supply 
follow the steps below.
1.  Unscrew the retaining screw from the EB-1 base 

plate and remove the EB-1 assembly from the  
appliance. (Fig. 9)

2.  Remove the front cover of the EB-1 box.
3.  Remove the plug socket assembly from the EB-1 

box.

4.  Feed the supply line in through the EB-1 opening in 

the side of the appliance and then through the back 
of the EB-1 assembly. (Fig. 9)

5.  Connect the black wire of the power supply line to 

the brass screw (polarized) of the socket assembly.

6.  Connect the white wire of the power line to the 

chrome screw of the socket assembly.

7.  Connect the ground wire of the supply line to the 

green screw of the socket assembly.

8.  Refit the socket assembly back into the electrical 

box and replace the cover plate. Secure the cable 
with the clamp on the outside of the EB-1 base 
plate and refit the EB-1 assembly to the unit with the 
screw removed in step 1.

FP580
INSTA VENT FREE
EB1 JUNCTION BOX
11/18/97

Electrical Box

FP580

Fig. 9  EB-1 receptacle.

wall thermostat on electronic ignition units. 
1.  Thread the wiring through the holes on the side 

panels of the appliance. Take care not to cut the wire 

or insulation on metal edges. Route the wire to a 

conveniently located receptacle box.

2.  Attach the wire to the ON/OFF switch and install the 

switch into the receptacle box.

POWER CORD

CIRCUIT BOARD

ON/OFF SWITCH
     OR
WALL THERMOSTAT

VALVE

RED

WHITE

BLUE

YELLOW

PURPLE

BLACK

WHITE

GREEN

PILOT SENSING

PILOT IGNITER

ORANGE

L1

L2

M
O

P

O

FP1571
SIT822 
Synetek wiring
4/05

Fig. 10  SIT822 Valve with Synetek electronic control wiring diagram.

FP1571