Regency P42-LP4 User Manual

Regency

®

 P42-4 Zero Clearance Direct Vent Gas Fireplace

1)  Shut off the gas supply.

2)  Remove the louvers (and bay door if it is 

on).

3)  Disconnect the inlet gas line.

4)  Disconnect the 2 TP wires and the 2 TH 

wires from the valve.

5)  Remove the Piezo igniter wire.  

6)  Open and remove the fl ush door.

7)  Remove the logs.

8)  Remove the burner tube by removing the 3 

Phillips head screws and then lift the burner 
out.

9)  Remove the burner grate assembly by 

removing the 3 Phillips head screws on the 
feet of the grate assembly.

10) Brush away all the vermiculite and embers 

from the right hand half of the fi replace.

11) Remove the top and right hand side brick 

panels.

12) Remove the 12 Phillips head screws securing 

the valve access plate in place and then lift 
the entire assembly out.

13) Undo the pilot tube from the valve with a 
 7/16" 

wrench.

14) Undo the quick drop out thermocouple nut 

on the valve with a 9mm wrench.

15) Undo the "gas out" fl are nut with a 13/16" 

wrench.

16) Undo the "gas out" 90

o

 elbow fl are fi tting with 

an 11/16" wrench.

17) Remove the 4 Phillips head screws from 

the sides of the valve bracket and remove 
valve.

1)  Shut the power off.

2)  Remove the bottom louver. 

3)  Remove terminal block cover and disconnect 

the fan wires.

4)  Disconnect white fan wire from the terminal 

block.

5)  Disconnect black fan wire from the 

thermodisc.

6) Disconnect 

fan 

ground 

wire.

7)  Lift the fan off the two mounting studs and 

pull out.

2)  Remove the bottom louver. Slide the fan in 

and push it towards the rear of the unit and 
slip it over the two mounting studs.

3)  Remove the terminal block cover. Wire the 

fan to the terminal block as shown in the 
wiring diagram below.

4)  Connect white wire from fan to neutral of 

terminal block.

5)  Connect black wire from fan to the 

thermodisc.

6)  Connect fan ground wire. Refer to wiring 

diagram.

7)  Attach the ground wire to the fi replace 

(ground lug provided).

8)  Attach the terminal block cover.