Regency P40-NG1 User Manual

Regency

®

 P40-1 Direct Vent Gas Fireplace

INST

ALLA

TION

The appliance must be isolated from the gas 
supply piping system by closing its individual 
manual shut-off valve during any pressure 
testing of the gas supply piping system at 
test pressures equal to or less than 1/2 psig. 
(3.45  kPa).  Disconnect piping from valve at 
pressures over 1/2 psig.

The manifold pressure is controlled by a regulator 
built into the gas control, and should be checked 
at the pressure test point.

1)  Make sure the valve is in the "OFF" 

position.

2)  Loosen the "IN" and/or "OUT" pressure 

tap(s), turning counterclockwise with a 

 1/8" 

wide 

fl at screwdriver.

3)  Attach manometer to "IN" and/or "OUT" 

pressure tap(s) using a 5/16" ID hose.

4)  Light the pilot and turn the valve to "ON" 

position.

5)  The pressure check should be carried out 

with the unit burning and the setting should 
be within the limits specifi ed on the safety 
label.

6) When fi nished reading manometer, turn 

off the gas valve, disconnect the hose and 
tighten the screw (clockwise) with a 1/8" fl at 
screwdriver. Note: Screw should be snug, 
but do not over tighten.

(within Power Module)

1)  Unplug the power source.

2)  Remove the Power Module by lifting it up 

off of the velcro and pull out.

3)  Remove the Power Module cover by 

removing the 2 screws, one on each side 
of the box.

4)  Install the 9V and AA battery.

1)  Gas on/off knob
2)  Electronically Operated Hi/Lo
3) Pilot 

Adjustment

4)  Thermocouple Connection - option
5)  Outlet Pressure Tap
6) Inlet Pressure Tap
7) Pilot Outlet
8)  Main Gas Outlet
9)  Alternative TC Connection Point

IN

OUT

1

3

5

6

4

2