Regency P40-NG1 User Manual

Regency

®

 P40-1 Direct Vent Gas Fireplace

INST

ALLA

TION

NOTE:  Install Finishing Trim prior to installing 
the Flush Door and Louvers.

1)  The standard fl ush door comes with a black 

frame. To install the frame, simply hook the 
top door fl ange onto the top of the unit and 
swing the door towards the unit, diagram 
1.

2)   Be careful that the glass gasket does not 

roll up; there must be a gap between the 
gasket and the door lip to ensure that the 
door sits securely on the unit. Diagram 2.

3)   Use the hook to pull the spring out until you 

can put the hook into the slot on the bottom 
door bracket. Repeat for 2nd spring.  See 
diagram 3.

 
4)  To remove the fl ush door, reverse the above 

steps.

NOTE:  Install Finishing Trim prior to installing 
the Flush Door and Louvers.

1)  Install the top louver by sliding the two bracket 

clips into the brackets located underneath 
the top of the fi rebox.

2)  Install the bottom louver by securing the 

louver onto the 2 hinges provided.

a)  Ensure that the bottom louver is open.

b)  Pull out the Manual Control Box from the 

right side under the bottom of the fi rebox.

c)  Using the 2 screws on the louver, secure 

the control box onto the right side of the 
louver.

The rear burner aeration is factory set but may 
need adjusting due to either the local gas supply 
or altitude. 

The rear burner air shutter can be adjusted by 
moving the air shutter  knob located at the front 
left bottom louver opening. Open (pull) the air 
shutter wire for a blue fl ame or close (push) for 
a more yellow fl ame.

* The front burner aeration is factory set, do not       
adjust this setting.