Regency P40-NG1 User Manual

Regency

®

 P40-1 Direct Vent Gas Fireplace

INST

ALLA

TION

Leave these two

screws secured

Remove the

center screw

Loosen these

four screws

Leave these two

screws secured

Cut Outs

Oblong

Hole

Top Flange

Bottom Flange

Cut Outs

  Before beginning the installation; if already installed, 

remove the Top and Bottom Louvers, the  Manual 
Control Box and the Glass Door from the unit.  Refer 
to the manual for instructions and reverse the steps 
(See Page 32). 

  Remove the Screen Doors from the Full Screen Door 

Frame by fully opening the doors and lifting up off of 
the hinges. See important note in step 9.

  Install the Hinges to the Hinge Brackets on the left 

and right side of the bottom of the outer frame, se-
cure using 2x #8 Self Tapping Phillips Screws per 
hinge.

Full Screen
Door Frame 

  Slide the cut-outs in the Top and Bottom Flange 

of the Full Screen Door Frame under the screw 
heads which were loosened in step 4a. Once the 
Frame is in place, tighten the screws to secure. 
Also re-secure the top center screw through the 
oblong hole.

  Full Screen Door Frame Installation

 Before attaching the Full Screen Door Frame 

to the unit, loosen the left and right side #8 Self 
Tapping Phillips Screws located on the inside top 
of the outer frame of the appliance. Also remove 
the center screw.

  Should the fi nished wall protrude beyond the 

face of the unit, you can accommodate up to 
1/2" discrepancy in depth.